Abstract. We present experimental and numerical results of the effect that a partial discharge has on the morphological and micro-mechanical properties of non-spherical, convex particles in a silo. The comparison of the particle orientation after filling the silo and its subsequent partial discharge reveals important shearinduced orientation, which affects stress propagation. For elongated particles, the flow induces an increase in the packing disorder which leads to a reduction of the vertical stress propagation developed during the deposit generated prior to the partial discharge. For square particles, the flow favors particle alignment with the lateral walls promoting a behavior opposite to the one of the elongated particles: vertical force transmission, parallel to gravity, is induced. Hence, for elongated particles the flow developed during the partial discharge of the silo leads to force saturation with depth whereas for squares the flow induces hindering of the force saturation observed during the silo filling.

We experimentally analyze the compaction dynamics of an ensemble of cubic particles submitted to a novel type of excitation. Instead of the standard tapping procedure used in granular materials we apply alternative twists to the cylindrical container. Under this agitation, the development of shear forces among the different layers of cubes leads to particle alignment. As a result, the packing fraction grows monotonically with the number of twists. If the intensity of the excitations is sufficiently large, an ordered final state is reached where the volume fraction is the densest possible compatible with the boundary condition. This ordered final state resembles the tetratic or cubatic phases observed in colloids.

No abstract

In a previous paper [Hidalgo et al., Phys. Rev. Lett. 103, 118001 (2009)] it was shown that square particles deposited in a silo tend to align with a diagonal parallel to the gravity, giving rise to a deposit with very particular properties. Here we explore, both experimentally and numerically, the effect on these properties of the filling mechanism. In particular, we modify the volume fraction of the initial configuration from which the grains are deposited. Starting from a very dilute case, increasing the volume fraction results in an enhancement of the disorder in the final deposit characterized by a decrease of the final packing fraction and a reduction of the number of particles oriented with their diagonal in the direction of gravity. However, for very high initial volume fractions, the final packing fraction increases again. This result implies that two deposits with the same final packing fraction can be obtained from very different initial conditions. The structural properties of such deposits are analyzed, revealing that, although the final volume fraction is the same, their micromechanical properties notably differ.

No abstract