The electrochemical behavior of a carbon steel in 3% NaC1 solution has been investigated using a rotating disk electrode. Both steady-state (diffusional current vs. the disk angular velocity plots) and transient (frequency analysis of the electrohydrodynamical impedance) measurements which specifically sample mass transport phenomena, have been carried out. It is shown that oxygen transport takes place not only in the liquid phase but also through a porous layer of corrosion products. From electrochemical impedance measurements, it was found that at the corrosion potential the oxygen reduction reaction is under either diffusional or mixed (activation + diffusion) control depending on both the electrode rotation speed and on the hold time at the free corrosion potential. In addition, it was shown that the oxygen consumption occurs not only by electrochemical reduction but also by chemical oxidation of ferrous to ferric ions. Finally, because of the possible occurrence of mixed corrosion control, it is emphasized that the Use of the polarization resistance in order to evaluate corrosion rates is not always valid.In a previous study (1), steady-state electrochemical techniques (voltage-current curves and polarization resistance measurements) were used to study the corrosion of carbon steel in a stirred and aerated chloride solution (3% NaCI). It was concluded that the corrosion rate is controlled by the reduction of dissolved oxygen, and that the corrosion rate deduced from electrochemical techniques is in fair agreement with that obtained from an absolute measurement such as the determination of the amount of iron species in solution.In the literature, many stud/es have been devoted to corrosion (and inhibition) in acidic media in order to measure the corrosion rate or to identify the elementary processes. However, relatively few studies have been carried out in neutral media (2), probably because of the formation of insoluble corrosion products which adhere to the metal surface (3a, b).In this work, we aimed firstly to be more precise about the quantitative influence of mass transport in the corrosion process. This was achieved by the use of specific analytical methods, such as plotting of the diffusional component vs. the angular velocity Of a disk electrode, and by the frequency analysis of the so-called EHD impedance {4).Secondly, in order to separate the elementary anodic and .cathodic contributions near to the corrosion po-Key words: interface, disk electrode, porous films, activationdiffusion.tential, and, therefore, to get a better insight of the mechanism, we carried out electrochemical impedance measurements for various polarization conditions.
The mass‐transfer response of a rotating disk electrode to a sine wave modulation of the angular velocity has been calculated for an interface covered by a porous layer of thickness
δnormalf
, through which an ionic species is transported by molecular diffusion with a diffusivity
Dnormalf
. Electrohydrodynamical (EHD) impedances, defined as the transfer functions between the response of the concentration or concentration gradient at the interface and the modulated velocity, have been expressed as functions of a dimensionless frequency p, representing the ratio of the modulation frequency to the average angular velocity, of the permeability
Dnormalf/δnormalf
and of the diffusion time constant through the film
δnormalf2/Dnormalf
. The frequency analysis of the impedance data for a coated electrode, therefore, allows one to determine
Dnormalf
and
δnormalf
separately.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.