The Venturi scrubber, equipment frequently used in the removal of particles from gases, is constituted basically by a duct with a convergent section followed by a constriction, or throat, and a divergent section. A liquid, usually injected in the throat, is atomized by the flowing air at high speed. The formed droplets act as collectors of particles from the gas. The process of droplet formation from an injected liquid can be described as follows: the liquid enters the gas stream in the form of a jet, perpendicular to the gas flow. As the jet penetrates the gas stream, it is bent by the gas drag. After a given penetration distance, a burst occurs, and the remaining jet is disintegrated as a droplet cloud. Depending on the liquid and gas flow rates, the penetration on the jet into the gas stream may reach the walls of the equipment, and a fraction of liquid deposits in the form of a film. This film contributes little for the removal of particles from the dust laden gas. Few studies have analyzed the formation of film at the scrubber walls and its influence in the droplet size inside the Venturi scrubber. For this reason, the present study is focused on the experimental measurement of the deposition of the liquid film on the walls of a rectangular Venturi scrubber and, simultaneously, the estimation of the droplet size measured in the Venturi throat. The experiments were carried out varying the liquid flow rate, the gas velocity and the number of orifices of liquid injection. A correlation, using a dimensionless number, was proposed to quantify the influence of each experimental condition. The results indicate that film fraction has a significant influence in the droplet size measured inside of Venturi scrubber.
The Venturi scrubber, equipment frequently used in the removal of particles from gases, is constituted basically by a duct with a convergent section followed by a constriction, or throat, and a divergent section. A liquid, usually injected in the throat, is atomized by the flowing air at high speed. The formed droplets act as collectors of particles from the gas. The size and the size distribution of the droplets inside the equipment are therefore of great importance in the equipment performance. In the present work, the liquid jet penetration is visualized and the study of the droplet formation in a rectangular Venturi is carried out. The liquid injection is made through multiple orifices and the interaction of multiple jets is taken into account. In the experimental tests, the gas velocity in the throat, the liquid flow rate and the number of orifices for liquid injection were varied. A Malvern Spraytec aerosol analyzer was used for measuring of the droplet size and size distribution. The results showed that the liquid jet penetration influences significantly the size of the formed droplet.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.