Impact Factor:ISRA (India) = 1.344 ISI (Dubai, UAE) = 0.829 GIF (Australia) = 0.564 JIF = 1.500 SIS (USA) = 0.912 РИНЦ (Russia) = 0.207 ESJI (KZ) = 4.102 SJIF (Morocco) = 2.031 ICV (Poland) = 6.630 PIF (India) = 1.940 IBI (India) = 4.260
Philadelphia, USA 132Abstract: The results of computer simulation of metal mold casting of cast iron and aluminium pistons for an automobile are presented in the article. Analysis of casting flaws into the pistons materials obtained at the different conditions of casting: values changing of melts flows, adding of the second vent, adding of a feeding point, a metal mold tilt and changing of the casting orientation into the mold was performed. Rapid cooling of aluminium melt leads to incomplete filling of the metal mold channels without additional elements of a gating system. Complete filling of the mold and the lowest deformation of material after cooling are ensured by changing of the aluminium casting orientation into the mold (by 180 degrees). Casting of the cast iron pistons is recommended to perform by adding of the second vent and the feeding point, as well as when the metal mold tilt by 90 degrees.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.