No abstract

This paper considers improving the confidentiality of visible light communication (VLC) links within the framework of physical-layer security. We study a VLC scenario with one transmitter, one legitimate receiver, and one eavesdropper. The transmitter has multiple light sources, while the legitimate and unauthorized receivers have a single photodetector, each. We characterize secrecy rates achievable via transmit beamforming over the multiple-input, single-output (MISO) VLC wiretap channel. For VLC systems, intensity modulation (IM) via lightemitting diodes (LEDs) is the most practical transmission scheme. Because of the limited dynamic range of typical LEDs, the modulating signal must satisfy certain amplitude constraints. Hence, we begin with deriving lower and upper bounds on the secrecy capacity of the scalar Gaussian wiretap channel subject to amplitude constraints. Then, we utilize beamforming to obtain a closed-form secrecy rate expression for the MISO wiretap channel. Finally, we propose a robust beamforming scheme to consider the scenario wherein information about the eavesdropper's channel is imperfect due to location uncertainty. A typical application of the proposed scheme is to secure the communication link when the eavesdropper is expected to exist within a specified area. The performance is measured in terms of the worst-case secrecy rate guaranteed under all admissible realizations of the eavesdropper's channel.

Visible light communication (VLC) re-uses illumination devices, in particular light-emitting diodes (LEDs), for communication purposes. It has great potential to alleviate the strain on radio frequency spectrum in indoor environments. VLCenabled LED luminaries form VLC attocells that carry downlink data traffic to indoor mobile or stationary terminals. While one of the advantages of indoor VLC is low interference due to natural cell boundaries such as walls, multiple VLC attocells within a room would interfere. This is because illumination requirements often mandate a rich overlap of emissions of luminaries in a room. In this paper, we suggest the coordination of multiple VLC attocells (i.e., VLC-enabled LED luminaries) to turn the problem of overlap and thus interference into an advantage. We stipulate that this coordination can be accomplished through power line communication (PLC), which has been considered before as a means to transport data to VLC transmitters. Borrowing from concepts developed for radio-frequency wireless communications, we develop several precoding schemes for the new coordinated VLC broadcasting architecture. These include designs for the case of imperfect channel knowledge at the VLC transmitter, since channel information is usually provided through a lowrate feedback channel. The performance advantages for VLC transmission due to the proposed coordination and precoding designs are demonstrated based on a set of numerical results.

No abstract

No abstract

No abstract

In recent decades, power line communication has attracted considerable attention from the research community and industry, as well as from regulatory and standardization bodies. In this article we provide an overview of both narrowband and broadband systems, covering potential applications, regulatory and standardization efforts and recent research advancements in channel characterization, physical layer performance, medium access and higher layer specifications and evaluations. We also identify areas of current and further study that will enable the continued success of power line communication technology.essentially concerned with coexistence with other systems that also use the power grid (i.e. machines and appliances that draw electricity) and wireless systems operating in the same frequency bands as PLC. The frequency range used for today's PLC solutions starts as low as 125 Hz and reaches as high as 100 MHz. A useful classification of PLC systems according to frequency bands has been introduced in [28]: it distinguishes between ultra-narrowband (UNB), narrowband (NB) and broadband (BB) PLC systems, operating between about 125-3000 Hz, 3-500 kHz and 1.8-100 MHz, respectively. Most recent developments in standardization and regulation activities over the past 20 or so years apply to NB and BB PLC systems, and we will focus on these in the following.

No abstract