No abstract

BackgroundThe insecticide dichloro-diphenyl-trichloroethane (DDT) is widely used in indoor residual spraying (IRS) for malaria control owing to its longer residual efficacy in the field compared to other World Health Organization (WHO) alternatives. Suitable stabilization to render these alternative insecticides longer lasting could provide a less controversial and more acceptable and effective alternative insecticide formulations than DDT.MethodsThis study sought to investigate the reasons behind the often reported longer lasting behaviour of DDT by exposing all the WHO approved insecticides to high temperature, high humidity and ultra-violet light. Interactions between the insecticides and some mineral powders in the presence of an aqueous medium were also tested. Simple insecticidal paints were made using slurries of these mineral powders whilst some insecticides were dispersed into a conventional acrylic paint binder. These formulations were then spray painted on neat and manure coated mud plaques, representative of the material typically used in rural mud houses, at twice the upper limit of the WHO recommended dosage range. DDT was applied directly onto mud plaques at four times the WHO recommended concentration and on manure plaques at twice WHO recommended concentration. All plaques were subjected to accelerated ageing conditions of 40°C and a relative humidity of 90%.ResultsThe pyrethroids insecticides outperformed the carbamates and DDT in the accelerated ageing tests. Thus UV exposure, high temperature oxidation and high humidity per se were ruled out as the main causes of failure of the alternative insecticides. Gas chromatography (GC) spectrograms showed that phosphogypsum stabilised the insecticides the most against alkaline degradation (i.e., hydrolysis). Bioassay testing showed that the period of efficacy of some of these formulations was comparable to that of DDT when sprayed on mud surfaces or cattle manure coated surfaces.ConclusionsBioassay experiments indicated that incorporating insecticides into a conventional paint binder or adsorbing them onto phosphogypsum can provide for extended effective life spans that compare favourably with DDT's performance under accelerated ageing conditions. Best results were obtained with propoxur in standard acrylic emulsion paint. Similarly, insecticides adsorbed on phosphogypsum and sprayed on cattle manure coated surfaces provided superior lifespans compared with DDT sprayed directly on a similar surface.

The processing and properties of layered double hydroxides (LDHs)‐containing polypropylene (PP) composites have been studied extensively. However, no detailed studies have reported on how stearic acid (SA)‐intercalated and SA‐coated LDHs influence the properties of melt‐processed PP/LDH composites. Here, four different types of LDHs: synthesized (cLDH1) and commercial (cLDH2) SA‐coated LDH, SA‐intercalated LDH (iLDH), and unmodified LDH (nLDH), were used to fabricate composites using a master‐batch‐dilution technique in a twin‐screw extruder. The characterization results showed that microcomposites were formed when cLDH2 and nLDH were used, whereas nanocomposites were formed when iLDH and cLDH1 were used. Strong nucleating behavior was observed for the nLDH‐, cLDH1‐, and cLDH2‐containing composites, whereas iLDH delayed the crystallization process of the PP matrix. A significant improvement in modulus, with a balance of tensile and impact strengths, was observed in the case of the cLDH1‐containing composite, whereas the nLDH‐containing composite showed good improvement in temperature‐dependent load‐bearing capacity. On the other hand, the PP/iLDH composite showed a remarkable improvement in thermal stability and a reduction in the peak‐heat‐release rate. Therefore, this study gives us an opportunity to design PP composites with desired properties by the judicious choice of LDH, which further widens the application of PP matrices. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017, 134, 45024.

No abstract