Vinasse is produced at high amounts by the ethanol and sugarcane spirits industries. Although the effects of vinasse on soil attributes are well elucidated, little is known about its effects on sorption and leaching of lead (Pb) from soils. This work evaluated the Pb sorption and leaching from disturbed topsoil samples (0-20 cm) of an Inceptisol, under the influence of sugarcane vinasse. Pb sorption was evaluated by batch sorption method, using air-dried samples (< 2 mm) treated with pure (100%), and diluted (20%, and 50%) vinasse. The amended soil samples were further reacted with 0.05; 0.10; 0.25; 0.50, and 0.75 mmol L -1 of Pb. To measure the Pb leached, soil columns were packed in PVC tubes, 12-cm long with 4-cm internal diameter filled with 200 g of treated soil. The vinasse doses applied over the columns corresponded to 0 (control), 150 and 300 m 3 ha -1 . Seven days later, 5 mL of a Pb solution (100 mmol L -1 ) was applied on the columns; they were successively leached and Pb was measured in the leachates. The vinasse increased the maximum sorption capacity and binding energy of Pb with the soil when at equilibrium conditions. However, at non-equilibrium conditions, the vinasse enhanced the Pb leaching. From these results, it is advised that special attention must be given to Pb contaminated areas where vinasse is applied. Key words: sugarcane cultivation, organometallic complexes, organic waste, Pb mobility Sorção e lixiviação de chumbo em amostra de um Cambissolo tratado com vinhaça de cana-de-açúcar RESUMO: A vinhaça é produzida em grandes quantidades pela indústria de etanol e de aguardente (cachaça). Embora os efeitos da vinhaça nos atributos do solo sejam bem conhecidos, pouco se sabe sobre eles no comportamento sortivo de chumbo (Pb). Avaliaram-se a sorção e a lixiviação de Pb em amostras da camada superficial (0-20 cm) de um Cambissolo Háplico Tb Distrófico típico (CXbd) sob influência da vinhaça. Para o ensaio de sorção, as amostras foram peneiradas em malha de 2 mm, tratadas com vinhaça diluída 20% e 50% e ao natural (100%), empregando água destilada nas amostras controle. Em seguida, soluções com 0,05; 0,10; 0,25; 0,50 e 0,75 mmol L -1 de Pb foram adicionadas às amostras de solo. Para o ensaio de lixiviação, foram preparadas colunas de solo em tubos de PVC de 12 cm de altura e 4 cm de diâmetro interno, contendo 200 g de solo. As doses de vinhaça aplicadas sobre as colunas foram correspondentes a 150 e 300 m 3 ha -1 . As colunas foram mantidas incubadas com vinhaça por sete dias. Após esse período, foram aplicados sobre cada coluna 5 mL de uma solução de concentração 100 mmol L -1 de Pb e, posteriormente, realizadas sucessivas lixiviações, coletando-se o percolado para determinação do teor de Pb. A vinhaça aumentou a capacidade máxima de adsorção de Pb e sua energia de ligação com o solo em condições de equilíbrio (ensaio de sorção), mas em condições de não equilíbrio (ensaio de lixiviação em colunas), a vinhaça aumentou a lixiviação de Pb. Com base nesses resultados, atenção especial ...
RESUMOObjetivou-se, neste trabalho, quantificar o efeito da vinhaça no comportamento compressivo e nos atributos mecânicos, como consistência, umidade ótima de compactação e densidade máxima, de um Latossolo Vermelho-Amarelo (LVA); avaliar o efeito da vinhaça e do estado de compactação no salpicamento de partículas, da região de Lavras, MG. A vinhaça foi proveniente de um alambique de cachaça artesanal. Foram coletadas amostras deformadas e indeformadas nas profundidades de 0 a 3 cm e 60 a 63 cm. As amostras deformadas destinaram-se à caracterização do solo, determinação dos limites de consistência e realização do ensaio de Proctor Normal, após a incubação do material com vinhaça. As amostras indeformadas foram saturadas com vinhaça ou água destilada (controle), por 48 horas e destinaram-se aos ensaios de compressibilidade e resistência ao salpicamento, usando-se um minisimulador de chuvas. A vinhaça alterou os limites de consistência das camadas estudadas. Para a camada de 0-3 cm a vinhaça reduziu a faixa friável e para a camada 60-63 cm aumentou. Para ambas as camadas, a vinhaça aumentou a D máx e reduziu a U ótima . As camadas 0-3 cm e 60-63 cm, independentemente do tratamento com vinhaça, apresentaram a mesma capacidade suporte de carga. O estado de compactação das amostras influenciou a erosão por salpicamento. O aumento da pressão aplicada sobre as amostras resultou no aumento da quantidade de material salpicado. Na camada 60-63 cm, o tratamento com vinhaça reduziu a quantidade de material salpicado com o aumento da pressão aplicada, notadamente com as amostras na capacidade de campo. Termos para indexação:Compressibilidade, capacidade suporte de carga, estrutura do solo, salpicamento, Proctor Normal. ABSTRACTThe objective of this study was to quantify the effect of plonk on compressive behavior and mechanical attributes such as consistency, optimum moisture for compaction and maximum density of a Red-Yellow Latosol (Oxisol) to evaluate the effect of plonk and compaction state in splashed particles, from Lavras (MG) region. The plonk was obtained from an artisanal sugarcane brandy alembic. Undisturbed and disturbed soil samples were collected at 0 to 3 cm and 60 to 63 cm depths. Disturbed soil samples were used for soil characterization, determination of consistence limits and Normal Proctor essay after material incubation with plonk. Undisturbed soil samples were saturated with plonk or distilled water (control) during 48 hours for testing the compressibility and resistance to splash by using simulated rainfall. The plonk altered the consistence limits of studied layers. For the 0-3 cm layer, the plonk reduced the friable range, and for the 60-63 cm layer the effect was in the opposite direction. For both layers, the plonk increased D max and decreased U optimum . Regardless of the plonk treatment, both layers presented the same load support capacity. The compaction degree of samples influenced the splash erosion. The increase of the applied pressure over the samples resulted in increase of splash materia...
Influência do sistema de manejo na retenção e mobilidade da atrazina em amostras de solos RESUMO A atrazina é um dos principais herbicidas utilizados no Brasil, no entanto, sua dinâmica nos solos ainda não é bem conhecida, principalmente com relação a diferentes sistemas de manejo. Dessa forma, o objetivo do trabalho foi avaliar a sorção e a lixiviação da atrazina em um Latossolo Vermelho distroférrico sob sistema de plantio direto e convencional. Para isso, o estudo de sorção foi realizado pelo método "batch" (ou em batelada) e de deslocamento miscível, em colunas de solo contendo amostras indeformadas da camada de 0-20 cm. Os resultados foram expressos pela isoterma de Freundlich e as curvas de eluição foram ajustadas ao modelo dispersivo-convectivo, obtendo-se assim o fator de retardamento (R) e o coeficiente de dispersão hidrodinâmica (D). Não houve diferença significativa do coeficiente de Freundlich (K f) nas amostras de solo sob o plantio direto e convencional. As amostras de solo da área sob plantio convencional apresentaram maior retardamento e menor dispersão hidrodinâmica em relação ao plantio direto, o que evidencia um maior fluxo. Isso sugere que a atrazina no solo sob plantio direto possui maior potencial de lixiviação no perfil do solo.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.