The most commons woods used for production of medium density particleboard (MDP) are Eucalyptus and Pinus. The Cajueiro and Amescla wood are typical trees coming from the center-west of Brazil, from the States of Mato Grosso and Tocatins. These are medium density woods similar to Pinus sp, the Brazilian's wood's industries usually used these woods only as piece of wood for structures or furniture. The purpose of this research is to investigate, in a preliminary study, the possibility of MDP panel's production using Cajueiro and Amescla wood species. The panels were produced under a pressure of 4 MPa for 10 minutes at 100°C, and it was produced a total of 12 MDP panels, 6 of Cajueiro and 6 of Amescla, with a thickness of 10mm, dimensions 250mm×250mm and 0.5 kg mass. For the bending modulus of elasticity, 2200 MPa were obtained for Cajueiro and 2700 MPa for Amescla, which are considered good values. The results can be considered satisfactory because it is a preliminary and unpublished study in the case of MDP panels manufactured with Cajueiro and Amescla wood species.
The purpose of this research is to demonstrate, in an original study, the potentiality of the use of Cajueiro (Anacardium sp.) and Amescla (Trattinikia sp.), two low density tropical wood species, for producing OSB (Oriented strand boards), structural panels that replace plywood for several building purposes. In those panels, wood strands can be disposed in a specific direction or in random distribution, in order to reach the desirable mechanical properties. In this case, the strands were oriented by a separator to generate layers in mass proportion 20:60:20 (outer, inner and outer layers). Then these pre-panels went to a pre-pressing to form the mattress. Finally, they were pressed at 100°C, by 10 minutes, under 4.5MPa pressure, using castor oil based bicomponent polyurethane resin as adhesive. They were produced eight panels (four with Cajueiro e four with Amescla), with nominal dimensions 350mm length, 350mm width and 10mm thickness. Results showed that these wood species can be used to produce OSB, mainly considering values obtained in mechanical tests, that are superior to OSB produced in Brazilian enterprises and can be classified as OSB/4, as recommended by European standard EN 300. Research should continue to be developed in order to reach more adequate performance in swelling and water absorption.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.