This paper reports an experimental and theoretical investigation of the effects of adding Fe to the perovskite strontium titanate SrTiO 3 . The effects include changes in the short-order range structure as well as in the electronic and electrical properties. X-ray diffraction analysis reveals that the

A detailed study of the structural, surface, and gas-sensing properties of nanostructured CoZnO films is presented. X-ray diffraction (XRD) analysis revealed a decrease in the crystallization degree with increasing Co content. The X-ray absorption near-edge structure (XANES) and X-ray photoelectron spectroscopies (XPS) revealed that the Co ions preferentially occupied the Zn sites and that the oxygen vacancy concentration increased as the amount of cobalt increased. Electrical measurements showed that the Co dopants not only enhanced the sensor response at low ozone levels (ca. 42 ppb) but also led to a decrease in the operating temperature and improved selectivity. The enhancement in the gas-sensing properties was attributed to the presence of oxygen vacancies, which facilitated ozone adsorption.

The sensitivity of ZnO-SnO 2 heterojunctions to ozone gas was investigated in this work, the two-phase materials of which were prepared via a hydrothermal route, resulting in nanocomposites in which the formation of heterojunctions was confirmed by microscopy analyses. While the sensing effectiveness of these materials is currently verified for application above 150 • C, these temperatures are here drastically reduced to room temperature by considering sensing activity under continuous UV irradiation, even for ozone concentrations as low as 20 ppb. This approach resulted in a fast sensing response, a short recovery time and a good selectivity compared to other gases, demonstrating a great potential of such heterojunctions for applications in environmental monitoring devices.

In this research, composites based on thermoplastic olefin (TPO) elastomers reinforced with natural fibers were developed, having had very interesting results, aiming toward an application in the automotive industry, for manufacturing car interior components. For the first time, sisal and coir fibers were used as reinforcement of TPO composites. The best-performing samples have had a successfully reduced maximum elongation and improved both maximum stress and Young's modulus values. Different compositions were studied regarding several parameters: type of fiber (coir or sisal treated and nontreated), coupling agent presence (maleic anhydride grafted polypropylene [MAPP]) and fiber content. Overall, the presence of fibers has had a clear positive impact on the composites' mechanical properties, enhanced by the presence of MAPP, mostly when using 4% (w/w) of fiber content. The fibers' surface treatment was especially important in this work, enabling the evaluation of the fibers' alkali treatment's influence in the final mechanical properties of the composites. The treatment successfully removed some of the most hydrophobic constituents of the natural fibers, like lignin, improving the possibility of a better adhesion of the fibers to the matrix. Finally, the mechanical properties of the composites were evaluated, and it was concluded that the alkali pretreatment had a very positive effect on several of them, aided by the presence of MAPP. POLYM. COMPOS., 40:3472-3481, 2019.