a b s t r a c tThis paper proposes an overarching review of national municipal waste management systems and wasteto-energy as an important part of it in the context of circular economy in the selected countries in Europe. The growth of population and rising standards of living means that the consumption of goods and energy is increasing. On the one hand, consumption leads to an increase in the generation of waste. On the other hand, the correlation between increased wealth and increased energy consumption is very strong as well. Given that the average heating value of municipal solid waste (MSW) is approximately 10 MJ/kg, it seems logical to use waste as a source of energy. Traditionally, waste-to-energy (WtE) has been associated with incineration. Yet, the term is much broader, embracing various waste treatment processes generating energy (for instance, in the form of electricity and/or heat or producing a wastederived fuel). Turning waste into energy can be one key to a circular economy enabling the value of products, materials, and resources to be maintained on the market for as long as possible, minimising waste and resource use. As the circular economy is at the top of the EU agenda, all Member States of the EU (including the EEA countries) should move away from the old-fashioned disposal of waste to a more intelligent waste treatment encompassing the circular economy approach in their waste policies. Therefore, the article examines how these EU policies are implemented in practice. Given that WtE traditionally is attached to the MSW management and organisation, the focus of this article is twofold. Firstly, it aims to identify the different practices of municipal waste management employed in selected countries and their approaches in embracing the circular economy and, secondly, the extent to which WtE technologies play any role in this context. The following countries, Estonia, Greece, Italy, Latvia, Lithuania, Norway, Poland, Slovenia, Spain, and the UK were chosen to depict a broad European context.

No abstract

No abstract

No abstract

The wetting of boron with liquid magnesium is a critical factor in the synthesis of MgB 2 bulk superconductors by the infiltration and growth (IG) process. Poor wetting characteristics can therefore result potentially in non-uniform infiltration, formation of defects in the final sample structure and poor structural homogeneity throughout the bulk material. Here we report the fabrication of near-net-shaped MgB 2 bulk superconductors by a modified precursor infiltration and growth (MPIG) technique. A homogeneous bulk microstructure has subsequently been achieved via the uniform infiltration of Mg liquid by enriching pre-reacted MgB 2 powder within the green precursor pellet as a wetting enhancer, leading to relatively little variation in superconducting properties across the entire bulk sample. Almost identical values of trapped magnetic field of 2.12 T have been measured at 5 K at both the top and bottom surfaces of a sample fabricated by the MPIG process, confirming the uniformity of the bulk microstructure. A maximum trapped field of 3 T has been measured at 5 K at the centre of a stack of two bulk MgB 2 samples fabricated using this technique. A steady rise in trapped field was observed for this material with decreasing temperature down to 5 K without the occurrence of flux avalanches and with a relatively low field decay rate (1.5%/d). These properties are attributed to the presence of a fine distribution of residual Mg within the bulk microstructure generated by the MPIG processing technique.