Continuous flow ventricular assist devices (cfVADs) while effective in advanced heart failure, remain plagued by thrombosis related to abnormal flows and elevated shear stress. To limit cfVAD thrombosis, patients utilize complex anti-thrombotic regimens built upon a foundation of aspirin (ASA). While much data exists on ASA as a modulator of biochemically-mediated platelet activation, limited data exists as to the efficacy of ASA as a means of limiting shear-mediated platelet activation, particularly under elevated shear stress common within cfVADs. We investigated the ability of ASA (20, 25 and 125 μM) to limit shear-mediated platelet activation under conditions of: 1) constant shear stress (30 dyne/cm2 and 70 dyne/cm2); 2) dynamic shear stress, and 3) initial high shear exposure (70 dyne/cm2) followed by low shear exposure – i.e. a platelet sensitization protocol, utilizing a hemodynamic shearing device providing uniform shear stress in vitro. The efficacy of ASA to limit platelet activation mediated via passage through a clinical cfVAD system (DeBakey Micromed) in vitro was also studied. ASA reduced platelet activation only under conditions of low shear stress (38% reduction compared to control, n = 10, p < 0.004), with minimal protection at higher shear stress and under dynamic conditions (n = 10, p > 0.5) with no limitation of platelet sensitization. ASA had limited ability (25.6% reduction in platelet activation rate) to modulate shear-mediated platelet activation induced via cfVAD passage. These findings, while performed under “deconstructed” non-clinical conditions by utilizing purified platelets alone in vitro, provide a potential contributory mechanistic explanation for the persistent thrombosis rates experienced clinically in cfVAD patients despite ASA therapy. An opportunity exists to develop enhanced pharmacologic strategies to limit shear-mediated platelet activation at elevated shear levels associated with mechanical circulatory support devices.

No abstract

Thrombotic events are associated with altered PAS values. Moreover, baseline elevated PAS values in patients who developed thrombotic events suggest patient-specific tendency to post-implant thromboembolic complications. Prospectively, systematic monitoring of PAS might guide the development of refined patient-tailored antithrombotic strategies and the technological improvement of LVAD design.

Despite the clinical success and growth in the utilization of continuous flow ventricular assist devices (cfVADs) for the treatment of advanced heart failure, hemolysis and thrombosis remain major limitations. Inadequate and/or ineffective anticoagulation regimens, combined with high pump speed and non-physiological flow patterns can result in hemolysis which often is accompanied by pump thrombosis. An unexpected increased in cfVADs thrombosis was reported by multiple major VAD implanting centers in 2014, highlighting the association of hemolysis, and a rise in lactate dehydrogenase (LDH) presaging thrombotic events. It is well established that thrombotic complications arise from abnormal shear stresses generated by cfVADs. What remains unknown is the link between cfVAD-associated hemolysis and pump thrombosis. Can hemolysis of red blood cells (RBCs) contribute to platelet aggregation thereby facilitating prothrombotic complication in cfVADs? Herein, we examine the effect of RBC-hemolysate and selected major constituents, i.e. LDH and plasma free hemoglobin (pHb) on platelet aggregation utilizing electrical resistance aggregometry. Our hypothesis is that elements of RBCs, released as a result of shear-mediated hemolysis, will contribute to platelet aggregation. We show that RBC-hemolysate and pHb, but not LDH, are direct contributors to platelet aggregation, posing an additional risk mechanism for cfVAD thrombosis.

Left ventricular assist devices (LVADs) have emerged as vital life-saving therapeutic systems for patients with advanced and end-stage heart failure (HF). Despite their efficacy, VAD systems remain limited by post-implantation thrombotic complications. Shear-mediated platelet activation is the major driver of such complications in these devices. Nowadays few platelet function assays are routinely utilized in assessing the degree of platelet activation in VAD implanted patients. No assays exist that specifically target shear-mediated platelet activation. The platelet activity state (PAS) is a novel assay that has been well validated in vitro, measuring thrombin release as a surrogate for shear-mediated platelet activation. To date limited data exist as to the utility of this assay in the clinical setting. In the present study we evaluated eight LVAD patients' platelet activation level using the PAS assay. Simultaneous measurements of conventional prothrombotic and hemolysis markers, - i.e. fibrinogen and lactate dehydrogenase (LDH) - were also performed. Trends as to alteration from baseline were studied. We observed that the PAS assay allowed detection of an abnormal level of platelet activation in one patient in our series who suffered from an overt thrombosis. Interestingly in the same patient no signal of major abnormality in fibrinogen or LDH was detected. Further for 7/8 patients who were free of thrombosis, no significant level of platelet activation was detected via PAS assay, while elevation in fibrinogen and LDH were observed. As such, from our observational series it appears that the PAS assay is a sensitive and specific indicator of shear-mediated platelet activation. Further patients' experience will help elucidate the role of this promising assay in the management of LVAD implanted patients.

Significant PAS reduction was observed for all drugs after exposure to 30dyne/cm constant shear stress, and all drugs but dipyridamole after exposure to the 30th percentile shear stress waveform of the cfVAD. However, only cilostazol was significantly effective after 70dyne/cm constant shear stress exposure, though no significant reduction was observed upon exposure to median shear stress conditions in the cfVAD. These results, coupled with the persistence of reported clinical thrombotic complication, suggest the need for the development of new classes of drugs that are especially designed to mitigate thrombosis in cfVAD patients, while reducing or eliminating the risk of bleeding.

Our results prove the feasibility of using microfluidics for the diagnosis of MCSD-related thrombotic risk. This study paves the way for the development of a miniaturized point-of-care device for monitoring AT drug regimen. Such a system may have significant impact on limiting the incidence of thrombosis in MCSD recipients.

Abstract:We designed an experimental setup to characterize the thrombogenic potential associated with blood recirculating devices (BRDs) used in extracorporeal circulation (ECC). Our methodology relies on in vitro flow loop platelet recirculation experiments combined with the modified-prothrombinase platelet activity state (PAS) assay to quantify the bulk thrombin production rate of circulated platelets, which correlates to the platelet activation (PA) level. The method was applied to a commercial neonatal hollow fiber membrane oxygenator. In analogous hemodynamic environment, we compared the PA level resulting from multiple passes of platelets within devices provided with phosphorylcholine (PC)-coated and noncoated (NC) fibers to account for flow-related mechanical factors (i.e., fluid-induced shear stress) together with surface contact activation phenomena. We report for the first time that PAS assay is not significantly sensitive to the effect of material coating under clinically pertinent flow conditions (500 mL/min), while providing straightforward information on shear-mediated PA dynamics in ECC devices. Being that the latter is intimately dependent on local flow dynamics, according to our results, the rate of thrombin production as measured by the PAS assay is a valuable biochemical marker of the selective contribution of PA in BRDs induced by device design features. Thus, we recommend the use of PAS assay as a means of evaluating the effect of modification of specific device geometrical features and/or different design solutions for developing ECC devices providing flow conditions with reduced thrombogenic impact.