The use of lightweight concrete in timber-concrete composite structures for the purposes of reconstruction, upgrading, and strengthening has increasing application potential. The correct combination of mechanical properties of both materials can preserve the beneficial aspects of timber in tension and concrete in compression, while reducing the weight of the structure. This paper experimentally evaluated the slip modulus of screw connectors as one of the key issues in the structural design of these types of composite structures. The results of four groups of push-out tests, which were performed on composite samples, are presented. All of the samples had identical cross sections, but each group was made with a different lightweight concrete density class according to Eurocode 2. The obtained results were compared with the values recommended by Eurocode 5. The analysis showed that the code recommendations yielded slip modulus values that were considerably higher than the ones obtained experimentally, which could lead to unsafe timber and lightweight concrete structures.

No abstract

No abstract

PurposeThe purpose of this paper is to contribute to the solution of the buckling and resonance stability problems in inelastic beams and wooden plane trusses, taking into account geometric and material defects.Design/methodology/approachTwo sources of non-linearity are analyzed, namely the geometrical non-linearity due to geometrical imperfections and material non-linearity due to material defects. The load-bearing capacity is obtained by the rheological-dynamical analogy (RDA). The RDA inelastic theory is used in conjunction with the damage mechanics to analyze the softening behavior with the scalar damage variable for stiffness reduction. Based on the assumed damages in the wooden truss, the corresponding external masses are calculated in order to obtain the corresponding fundamental frequencies, which are compared with the measured ones.FindingsRDA theory uses rheology and dynamics to determine the structures' response, those results in the post-buckling branch can then be compared by fracture mechanics. The RDA method uses the measured P and S wave velocities, as well as fundamental frequencies to find material properties at the limit point. The verification examples confirmed that the RDA theory is more suitable than other non-linear theories, as those proved to be overly complex in terms of their application to the real structures with geometrical and material defects.Originality/valueThe paper presents a novel method of solving the buckling and resonance stability problems in inelastic beams and wooden plane trusses with initial defects. The method is efficient as it provides explanations highlighting that an inelastic beam made of ductile material can break in any stage from brittle to extremely ductile, depending on the value of initial imperfections. The characterization of the internal friction and structural damping via the damping ratio is original and effective.

No abstract