Recently, much attention has been given to the development of biofunctionalized nanoparticles with magnetic properties for novel biomedical imaging. Guided, smart, targeting nanoparticulate magnetic resonance imaging (MRI) contrast agents inducing high MRI signal will be valuable tools for future tissue specific imaging and investigation of molecular and cellular events. In this study, we report a new design of functionalized ultrasmall rare earth based nanoparticles to be used as a positive contrast agent in MRI. The relaxivity is compared to commercially available Gd based chelates. The synthesis, PEGylation, and dialysis of small (3-5 nm) gadolinium oxide (DEG-Gd(2)O(3)) nanoparticles are presented. The chemical and physical properties of the nanomaterial were investigated with Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, transmission electron microscopy, and dynamic light scattering. Neutrophil activation after exposure to this nanomaterial was studied by means of fluorescence microscopy. The proton relaxation times as a function of dialysis time and functionalization were measured at 1.5 T. A capping procedure introducing stabilizing properties was designed and verified, and the dialysis effects were evaluated. A higher proton relaxivity was obtained for as-synthesized diethylene glycol (DEG)-Gd(2)O(3) nanoparticles compared to commercial Gd-DTPA. A slight decrease of the relaxivity for as-synthesized DEG-Gd(2)O(3) nanoparticles as a function of dialysis time was observed. The results for functionalized nanoparticles showed a considerable relaxivity increase for particles dialyzed extensively with r(1) and r(2) values approximately 4 times the corresponding values for Gd-DTPA. The microscopy study showed that PEGylated nanoparticles do not activate neutrophils in contrast to uncapped Gd(2)O(3). Finally, the nanoparticles are equipped with Rhodamine to show that our PEGylated nanoparticles are available for further coupling chemistry, and thus prepared for targeting purposes. The long term goal is to design a powerful, directed contrast agent for MRI examinations with specific targeting possibilities and with properties inducing local contrast, that is, an extremely high MR signal at the cellular and molecular level.

Ultrasmall gadolinium oxide nanoparticles doped with terbium ions were synthesized by the polyol route and characterized as a potentially bifunctional material with both fluorescent and magnetic contrast agent properties. The structural, optical, and magnetic properties of the organic-acid-capped and PEGylated Gd 2 O 3 :Tb 3+ nanocrystals were studied by HR-TEM, XPS, EDX, IR, PL, and SQUID. The luminescent/fluorescent property of the particles is attributable to the Tb 3+ ion located on the crystal lattice of the Gd 2 O 3 host. The paramagnetic behavior of the particles is discussed. Pilot studies investigating the capability of the nanoparticles for fluorescent labeling of living cells and as a MRI contrast agent were also performed. Cells of two cell lines (THP-1 cells and fibroblasts) were incubated with the particles, and intracellular particle distribution was visualized by confocal microscopy. The MRI relaxivity of the PEGylated nanoparticles in water at low Gd concentration was assessed showing a higher T 1 relaxation rate compared to conventional Gd-DTPA chelates and comparable to that of undoped Gd 2 O 3 nanoparticles.

In all kinds of gadolinium based contrast agents, the presence of free gadolinium ions have to be avoided due to the cytotoxicity. The conventional way of producing a gadolinium based contrast agent is to form a chelate, i.e. stabilizing the metal ion using a chelating agent (for example DTPA or DOTA) but recently nanoparticles is an initial step towards biocompatible and directed nanoparticles.The main focus is on a material that in the nearby future will be the core of an The experimental results are supported by theoretical modeling studies.Theoretical IR spectra of three different Gd acetate complexes are presented as well as calculated NEXAFS spectra of one of the Gd acetate complexes and an isolated acetate group. These calculations were performed to elucidate the molecular capping of the synthesized particles. 5 EXPERIMENTAL DETAILS ChemicalsAll chemicals were used as received. Gadolinium(III) acetate hydrate (SigmaAldrich, 99.9 %), tetramethylammonium hydroxide (Sigma-Aldrich, >97 % ), ethyl acetate (Fisher Scientific, 99.99 %), dimethyl sulfoxide (Merck, 99.9 %), ammonium acetate (Merck, >96%), ethanol (Kemetyl, 99.5 %). For preparation of water based solutions, Milli-Q water (ρ > 18.2 MΩ) was used. A commercial gadolinium oxide nanopowder (Aldrich, < 100 nm, 99.8 %) was used as a reference. Preparation of Gd 2 O 3 nanoparticlesThe preparation of Gd 2 O 3 nanoparticles was based on a method previously used for producing nanocrystalline ZnO (Schwartz et al. 2003). As Zn 2+ is divalent and Ethyl acetate was added and the mixture was centrifuge washed (3500 rpm) at least three times with ethyl acetate before it was diluted in deionized water. A total amount of 0.28 g ammonium acetate was added to one whole batch to increase the water solubility. Powder samples were air dried. The yield of the sample is dependent on the washing procedure. The gadolinium content after three times of centrifuge washing with ethyl acetate is roughly 60-65 % of the initial amount added in the synthesis.6 Instrumentation X-ray diffraction XRD measurements were carried out with a Philips XRD powder diffractometer using Cu Kα radiation (λ = 1.5418 Å, 40kV, 40 mA). The 2θ step-size was 0.025° and the time per step 4 s. Air dried powder samples were used in the preparation.High-resolution transmission electron microscopy TEM measurements were performed on a FEI Tecnai G 2 electron microscope operated at 200 kV. Sample preparation was done by letting 1-2 drops of Gd 2 O 3 in water dry on an amorphous carbon-covered copper grid.Dynamic light scattering DLS measurements were carried out on an ALV/DLS/SLS-5022F system from ALV-GmbH, Langen Germany, using a HeNe laser at 632.8 nm with 22 mW output power. Prior to the measurements, the samples were temperature stabilized in a thermostat bath at 22.1 °C for at least 10 minutes. The scattering angle was 90°. 15 Gd 2 O 3 samples dispersed in MilliQ water were studied in DLS, and the long term stability of the suspensions were studied by repeated measurements during a period of 6 weeks.ζ Pot...

Electrochemical synthesis and physical characterization of ZnO nanoparticles functionalized with four different organic acids, three aromatic (benzoic, nicotinic, and trans-cinnamic acid) and one nonaromatic (formic acid), are reported. The functionalized nanoparticles have been characterized by X-ray powder diffraction, transmission electron microscopy, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, UV-vis, and photoluminescence spectroscopy. The adsorption of the organic acids at ZnO nanoparticles was further analyzed and interpreted using quantum-chemical density-functional theory computations. Successful functionalization of the nanoparticles was confirmed experimentally by the measured splitting of the carboxylic group stretching vibrations as well as by the N(1s) and C(1s) peaks from XPS. From a comparison between computed and experimental IR spectra, a bridging mode adsorption geometry was inferred. PL spectra exhibited a remarkably stronger near band edge emission for nanoparticles functionalized with formic acid as compared to the larger aromatic acids. From the quantum-chemical computations, this was interpreted to be due to the absence of aromatic adsorbate or surface states in the band gap of ZnO, caused by the formation of a complete monolayer of HCOOH. In the UV-vis spectra, strong charge-transfer transitions were observed.

This study reports ZnO nanoparticles and thin film surface modification using a two-step functionalization strategy. A small silane molecule was used to build up a stabilizing layer and for conjugation of biotin (vitamin B7), as a specific tag. Biotin was chosen because it is a well-studied bioactive molecule with high affinity for avidin. ZnO nanoparticles were synthesized by electrochemical deposition under oxidizing condition, and ZnO films were prepared by plasma-enhanced metal-organic chemical vapor deposition. Both ZnO nanoparticles and ZnO thin films were surface modified by forming a (3-mercaptopropyl)trimethoxysilane (MPTS) layer followed by attachment of a biotin derivate. Iodoacetyl-PEG2-biotin molecule was coupled to the thiol unit in MPTS through a substitution reaction. Powder X-ray diffraction, transmission electron microscopy, X-ray photoemission electron microscopy, atomic force microscopy, X-ray photoelectron spectroscopy, and near-edge X-ray absorption fine structure spectroscopy were used to investigate the as-synthesized and functionalized ZnO materials. The measurements showed highly crystalline materials in both cases with a ZnO nanoparticle diameter of about 5 nm and a grain size of about 45 nm for the as-grown ZnO thin films. The surface modification process resulted in coupling of silanes and biotin to both the ZnO nanoparticles and ZnO thin films. The two-step functionalization strategy has a high potential for specific targeting in bioimaging probes and for recognition studies in biosensing applications.

No abstract

Water-dispersible and luminescent gadolinium oxide (GO) nanoparticles (NPs) were designed and synthesized for potential dual-modal biological imaging. They were obtained by capping gadolinium oxide nanoparticles with a fluorescent glycol-based conjugated carboxylate (HL). The obtained nanoparticles (GO-L) show long-term colloidal stability and intense blue fluorescence. In addition, L can sensitize the luminescence of europium(III) through the so-called antenna effect. Thus, to extend the spectral ranges of emission, europium was introduced into L-modified gadolinium oxide nanoparticles. The obtained EuIII-doped particles (Eu:GO-L) can provide visible red emission, which is more intensive than that without L capping. The average diameter of the monodisperse modified oxide cores is about 4 nm. The average hydrodynamic diameter of the L-modified nanoparticles was estimated to be about 13 nm. The nanoparticles show effective longitudinal water proton relaxivity. The relaxivity values obtained for GO-L and Eu:GO-L were r1=6.4 and 6.3 s−1 mM−1 with r2/r1 ratios close to unity at 1.4 T. Longitudinal proton relaxivities of these nanoparticles are higher than those of positive contrast agents based on gadolinium complexes such as Gd-DOTA, which are commonly used for clinical magnetic resonance imaging. Moreover, these particles are suitable for cellular imaging and show good biocompatibility.

Transition-metal oxides (TMOs) are potential candidates for anode materials of lithium-ion batteries (LIBs) due to their high theoretical capacity (∼1000 mA h/g) and enhanced safety from suppressing the formation of lithium dendrites. However, the poor electron conductivity and the large volume expansion during lithiation/delithiation processes are still the main hurdles for the practical usage of TMOs as anode materials. In this work, the CoSnO3@NC@MnO@NC hierarchical nanobox (CNMN) is then proposed and fabricated to solve those issues. The as-prepared nanobox contains hollow cubic CoSnO3 as a core and dual N-doped carbon-“sandwiched” MnO particles as a shell. As anode materials of LIBs, the hollow and carbon interlayer structures effectively accommodate the volume expansion while dual active TMOs of CoSnO3 and MnO efficiently increase the specific capacity. Notably, the dual-layer structure of N-doped carbons plays a critical functional role in the incorporated composites, where the inner layer serves as a reaction substrate and a spatial barrier and the outer layer offers electron conductivity, enabling more effective involvement of active anode materials in lithium storage, as well as maintaining their high activity during lithium cycling. Subsequently, the as-prepared CNMN exhibits a high specific capacity of 1195 mA h/g after the 200th cycle at 0.1C and an excellent stable reversible capacity of about 876 mA h/g after the 300th cycle at 0.5C with only 0.07 mA h/g fade per cycle after 300 cycles. Even after a 250 times fast charging/discharging cycle both at 5C, it still retains a reversible capacity of 422.6 mA h/g. We ascribe the enhanced lithium storage performances to the novel hierarchical architectures achieved from the rational design.