There was an increased risk of mortality from IHD associated with cumulative exposure to coal dust, and with coal rank. The effect of coal rank may be due differences in the composition of coal mine dust particulate. The association of risk of IHD mortality with cumulative particulate exposure is consistent with air pollution studies.

Elemental carbon (EC) is currently used as a surrogate for diesel particulate matter (DPM) in underground mines since it can be accurately measured at low concentrations and diesels are the only source of submicrometer EC in underground mines. A disadvantage of using EC as a surrogate for DPM is that the fraction of EC in DPM is a function of various engine parameters and fuel formulations, etc. In order to evaluate how EC predicts DPM in the underground mining atmosphere, measurements of total carbon (TC; representing over 80% of the DPM) and EC were taken away from potential interferences in four underground metal/non-metal mines during actual production. In a controlled atmosphere, DPM mass, TC, and EC measurements were also collected while several different types of vehicles simulated production with and without different types of control technologies. When diesel particulate filters (DPFs) were not used, both studies showed that EC could be used to predict DPM mass or TC. The variability of the data started to increase at TC concentrations below 230 microg/m3 and was high (> +/- 20%) at TC concentrations below 160 microg/m3, probably due to the problem with sampling organic carbon (OC) at these concentrations. It was also discovered that when certain DPFs were used, the relationship between DPM and EC changed at lower DPM concentrations.

The objectives of this study were to describe workplace noise exposures, risk factors for hearing loss, and hearing levels among sand and gravel miners, and to determine whether full shift noise exposures resulted in changes in hearing thresholds from baseline values. Sand and gravel miners (n = 317) were interviewed regarding medical history, leisure-time and occupational noise exposure, other occupational exposures, and use of hearing protection. Audiometric tests were performed both before the work shift (following a 12-hour noise-free interval) and immediately following the work shift. Full shift noise dosimetry was conducted. Miners' noise exposures exceeded the Recommended Exposure Limit (REL) of the National Institute for Occupational Safety and Health (NIOSH) for 69% of workers, and exceeded the Mine Safety and Health Administration's action level for enrollment in a hearing conservation program for 41% of workers. Significantly higher noise exposures occurred among employees of small companies, among workers with a job classification of truck driver, among males, and among black workers. Hearing protection usage was low, with 48% of subjects reporting that they never used hearing protection. Hearing impairment, as defined by NIOSH, was present among 37% of 275 subjects with valid audiograms. Black male workers and white male workers had higher hearing thresholds than males from a comparison North Carolina population unexposed to industrial noise. Small but statistically significant changes in hearing thresholds occurred following full shift noise exposure among subjects who had good hearing sensitivity at baseline. In a logistic regression model, age and history of a past noisy job were significant predictors of hearing impairment. Overall, sand and gravel workers have excessive noise exposures and significant hearing loss, and demonstrate inadequate use of hearing protection. Well-designed hearing conservation programs, with reduction of noise exposure, are clearly needed.

Diesel particulate matter (DPM) samples from underground metal/nonmetal mines are collected on quartz fiber filters and measured for carbon content using National Institute for Occupational Safety and Health Method 5040. If size-selective samplers are not used to collect DPM in the presence of carbonaceous ore dust, both the ore dust and DPM will collect on the quartz filters, causing the carbon attributed to DPM to be artificially high. Because the DPM particle size is much smaller than that of mechanically generated mine dust aerosols, it can be separated from the larger mine dust aerosol by a single-stage impactor. The SKC DPM cassette is a single-stage impactor designed to collect only DPM aerosols in the presence of carbonaceous mine ore aerosols, which are commonly found in underground nonmetal mines. However, there is limited data on how efficiently the SKC DPM cassette can collect DPM in the presence of ore dust. In this study we investigated the ability of the SKC DPM cassette to collect DPM while segregating ore dust from the sample. We found that the SKC DPM cassette accurately collected DPM. In the presence of carbon-based ore aerosols having an average concentration of 8 mg/m3, no ore dust was detected on SKC DPM cassette filters. We did discover a problem: the surface areas of the DPM deposits on SKC DPM cassettes, manufactured prior to August 2002 were inconsistent. To correct this problem, SKC modified the cassette. The new cassette produced, with 99% confidence, a range of DPM deposit areas between 8.05 and 8.28 cm2, a difference of less than 3%.