The large-scale practical application of fuel cells will be difficult to realize if the expensive platinum-based electrocatalysts for oxygen reduction reactions (ORRs) cannot be replaced by other efficient, low-cost, and stable electrodes. Here, we report that vertically aligned nitrogen-containing carbon nanotubes (VA-NCNTs) can act as a metal-free electrode with a much better electrocatalytic activity, long-term operation stability, and tolerance to crossover effect than platinum for oxygen reduction in alkaline fuel cells. In air-saturated 0.1 molar potassium hydroxide, we observed a steady-state output potential of -80 millivolts and a current density of 4.1 milliamps per square centimeter at -0.22 volts, compared with -85 millivolts and 1.1 milliamps per square centimeter at -0.20 volts for a platinum-carbon electrode. The incorporation of electron-accepting nitrogen atoms in the conjugated nanotube carbon plane appears to impart a relatively high positive charge density on adjacent carbon atoms. This effect, coupled with aligning the NCNTs, provides a four-electron pathway for the ORR on VA-NCNTs with a superb performance.

. ¶ These authors contributed equally.P latinum (Pt) nanoparticles have long been regarded as the best catalyst for the oxygen reduction reaction (ORR) in fuel cells, though the Pt-based electrode still suffers from its susceptibility to timedependent drift and CO deactivation. 1Ϫ3 Furthermore, the high cost of the Pt catalysts, together with the limited reserves of Pt in nature, has been shown to be the major "showstopper" to mass market fuel cells for commercial applications. That is why the large-scale practical application of fuel cells has not been realized, though alkaline fuel cells with platinum as an ORR electrocatalyst were developed for the Apollo lunar mission in the 1960s. 4 Along with recent intensive research efforts in reducing or replacing Ptbased electrodes in fuel cells, 3,5Ϫ11 we have found that vertically aligned nitrogencontaining carbon nanotubes (VA-NCNTs) produced by pyrolysis of iron(II) phthalocyanine (a metal heterocyclic molecule containing nitrogen), 12 in either the presence or absence of additional NH 3 vapor, 3 could act as effective metal-free ORR electrocatalysts. The metal-free VA-NCNTs were shown to catalyze a four-electron ORR process free from CO "poisoning" with a 3-time higher electrocatalytic activity, smaller crossover effect, and better long-term operation stability than that of commercially available Pt-based electrodes (C2Ϫ20, 20% platinumonVulcanXC-72R; E-TEK) in alkaline electrolytes. 3 On the basis of the experimental observations and quantum mechanics calculations, we attributed the improved catalytic performance to the electronaccepting ability of the nitrogen atoms, which creates a net positive charge on adjacent carbon atoms in the nanotube carbon plane of VA-NCNTs to readily attract electrons from the anode for facilitating the ORR. 3 Uncovering this new ORR mechanism in nitrogen-doped carbon nanotube electrodes is significant as the same principle could be applied to the development of various other metal-free efficient ORR catalysts for fuel cell applications.The recent discovery of graphene has opened up a new era of 2-dimensional (2D) fundamental science and potential technology. 13Ϫ15 As mother of all graphitic forms, graphene is a building block for carbon materials of all other dimensionalities, such as 0D buckyballs, 1D nanotubes, and 3D graphite. Having many similarities to carbon nanotubes (CNTs) in structure and property, including its high aspect ratio (the ratio of lateral size to thickness), large surface, rich electronic states, and good mechanical properties, graphene is an attractive candidate for potential uses in many areas where the CNTs have been exploited. Superior to CNTs, the one atomic-thick graphene sheets with a 2D planar geometry will further facilitate electron transport, 16 and hence the more effective electrode materials.

The oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) are traditionally carried out with noble metals (such as Pt) and metal oxides (such as RuO₂ and MnO₂) as catalysts, respectively. However, these metal-based catalysts often suffer from multiple disadvantages, including high cost, low selectivity, poor stability and detrimental environmental effects. Here, we describe a mesoporous carbon foam co-doped with nitrogen and phosphorus that has a large surface area of ∼1,663 m(2) g(-1) and good electrocatalytic properties for both ORR and OER. This material was fabricated using a scalable, one-step process involving the pyrolysis of a polyaniline aerogel synthesized in the presence of phytic acid. We then tested the suitability of this N,P-doped carbon foam as an air electrode for primary and rechargeable Zn-air batteries. Primary batteries demonstrated an open-circuit potential of 1.48 V, a specific capacity of 735 mAh gZn(-1) (corresponding to an energy density of 835 Wh kgZn(-1)), a peak power density of 55 mW cm(-2), and stable operation for 240 h after mechanical recharging. Two-electrode rechargeable batteries could be cycled stably for 180 cycles at 2 mA cm(-2). We also examine the activity of our carbon foam for both OER and ORR independently, in a three-electrode configuration, and discuss ways in which the Zn-air battery can be further improved. Finally, our density functional theory calculations reveal that the N,P co-doping and graphene edge effects are essential for the bifunctional electrocatalytic activity of our material.

No abstract

Graphene quantum dots (GQDs) represent a new class of quantum dots with unique properties. Doping GQDs with heteroatoms provides an attractive means of effectively tuning their intrinsic properties and exploiting new phenomena for advanced device applications. Herein we report a simple electrochemical approach to luminescent and electrocatalytically active nitrogen-doped GQDs (N-GQDs) with oxygen-rich functional groups. Unlike their N-free counterparts, the newly produced N-GQDs with a N/C atomic ratio of ca. 4.3% emit blue luminescence and possess an electrocatalytic activity comparable to that of a commercially available Pt/C catalyst for the oxygen reduction reaction (ORR) in an alkaline medium. In addition to their use as metal-free ORR catalysts in fuel cells, the superior luminescence characteristic of N-GQDs allows them to be used for biomedical imaging and other optoelectronic applications.

Co3 O4 , which is of mixed valences Co(2+) and Co(3+) , has been extensively investigated as an efficient electrocatalyst for the oxygen evolution reaction (OER). The proper control of Co(2+) /Co(3+) ratio in Co3 O4 could lead to modifications on its electronic and thus catalytic properties. Herein, we designed an efficient Co3 O4 -based OER electrocatalyst by a plasma-engraving strategy, which not only produced higher surface area, but also generated oxygen vacancies on Co3 O4 surface with more Co(2+) formed. The increased surface area ensures the Co3 O4 has more sites for OER, and generated oxygen vacancies on Co3 O4 surface improve the electronic conductivity and create more active defects for OER. Compared to pristine Co3 O4 , the engraved Co3 O4 exhibits a much higher current density and a lower onset potential. The specific activity of the plasma-engraved Co3 O4 nanosheets (0.055 mA cm(-2) BET at 1.6 V) is 10 times higher than that of pristine Co3 O4 , which is contributed by the surface oxygen vacancies.

It is estimated that the world will need to double its energy supply by 2050. Nanotechnology has opened up new frontiers in materials science and engineering to meet this challenge by creating new materials, particularly carbon nanomaterials, for efficient energy conversion and storage. Comparing to conventional energy materials, carbon nanomaterials possess unique size-/surface-dependent (e.g., morphological, electrical, optical, and mechanical) properties useful for enhancing the energy-conversion and storage performances. During the past 25 years or so, therefore, considerable efforts have been made to utilize the unique properties of carbon nanomaterials, including fullerenes, carbon nanotubes, and graphene, as energy materials, and tremendous progress has been achieved in developing high-performance energy conversion (e.g., solar cells and fuel cells) and storage (e.g., supercapacitors and batteries) devices. This article reviews progress in the research and development of carbon nanomaterials during the past twenty years or so for advanced energy conversion and storage, along with some discussions on challenges and perspectives in this exciting field.

Oxygen electrocatalysis, including the oxygen-reduction reaction (ORR) and oxygen-evolution reaction (OER), is a critical process for metal-air batteries. Therefore, the development of electrocatalysts for the OER and the ORR is of essential importance. Indeed, various advanced electrocatalysts have been designed for the ORR or the OER; however, the origin of the advanced activity of oxygen electrocatalysts is still somewhat controversial. The enhanced activity is usually attributed to the high surface areas, the unique facet structures, the enhanced conductivities, or even to unclear synergistic effects, but the importance of the defects, especially the intrinsic defects, is often neglected. More recently, the important role of defects in oxygen electrocatalysis has been demonstrated by several groups. To make the defect effect clearer, the recent development of this concept is reviewed here and a novel principle for the design of oxygen electrocatalysts is proposed. An overview of the defects in carbon-based, metal-free electrocatalysts for ORR and various defects in metal oxides/selenides for OER is also provided. The types of defects and controllable strategies to generate defects in electrocatalysts are presented, along with techniques to identify the defects. The defect-activity relationship is also explored by theoretical methods.