No abstract

The rotational molecular dynamics of water confined to nanoporous molecular sieves of a regular hexagonal (SBA-15) and of a foamlike pore structure was studied by dielectric spectroscopy in the frequency range from 10(-2) to 10(9) Hz and in a broad temperature interval. Two relaxation processes were observed: the process at lower frequencies is related to water molecules forming a layer, which is strongly adsorbed at the pore surface, whereas the relaxation process at higher frequencies is assigned to fluctuations of water molecules situated close to the center of the pore. The relaxation times of the low-frequency process for both materials and of the high-frequency process for the SBA-15 material have an unusual saddlelike temperature dependence, reported here for the first time. To describe this temperature dependence, a model developed for water confined to nanoporous glasses by Ryabov et al. [J. Phys. Chem. B 2001, 105, 1845] was applied, which considers two competing effects. The characteristic features of these two competing processes were compared with those reported for other porous systems.

Broad-band dielectric spectroscopy (10-2 to 109 Hz) is applied to investigate the molecular dynamics of NaY, a zeolite of faujasite structure. A dc conductivity contribution and three relaxation processes were revealed in the dielectric spectra. The relaxation process in the high-frequency range ascribed to orientational fluctuations of water molecules inside the sodalite cages is studied in detail. As a main result it is found that its mean relaxation time has an unusual saddle-like temperature dependence, which obeys neither an Arrhenius nor a Vogel−Fulcher−Tammann law. A quantitative description was given on the basis of a model recently developed by Feldman et al. (J. Phys. Chem. B 2001, 105, 1845) to analyze the dynamics of water confined in nanoporous glasses. Reasonable values for the activation energies of orientational fluctuations and of defect formation as well as for the defect concentration were obtained.

No abstract

No abstract

No abstract

A broadband dielectric study of the dispersions of silica spheres (Aerosil 380) in octylcyanobiphenyl (8CB) with densities between 0.083 and 10 g of silica per 1 cm 3 of liquid crystal (LC) is reported. High values of silica densities were achieved for the first time to observe the behaviour of the LC monolayer on the surface of the silica particles. The relaxation characteristic of the bulk LC is noticed especially for the samples with low silica densities. Additionally, a slow relaxation was detected, even at temperatures for which the bulk LC is in the crystalline state. It was assigned to the surface layer of LC molecules. Remarkably, the temperature dependence of the relaxation rates for this slow process shows a behaviour typical for glass-forming liquids.

Electroless deposition was successfully applied in developing crystalline particles of zinc oxide onto polyester textile materials; this deposition is here presented in comparison with other materials made from poly(lactic acid), polyamide or hemp. Structural and spectroscopic characterization of the raw and deposited samples has been performed. The structure of zinc oxide particles was that of wurtzite type as indicated by X‐ray diffraction (XRD) and scanning electron microscopy (SEM). Crystallites were 20–500 nm in diameter and up to 1 µm in length. The grown particles cover the fibers not only on the fabric surface but in the textile depth. Contact angle measurement by the sessile drop method was used to study the wettability behavior of the investigated composite systems. The hierarchical roughness structure generates superhydrophobic properties onto polyester fabrics, for which water contact angles exceed 150°. The other functionalized samples also become more hydrophobic after deposition. Cassie‐Baxter model was found suitable to describe the behavior, though the fraction of surface occupied by the water–solid interface is high enough. The electroless deposition technique applied previously for cotton fabrics was once more proven to be highly reproducible, easy scalable, and cheap, allowing a wide range of applications. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2013, 51, 1427–1437