Localized surface plasmon resonance properties in unconventional materials like metal oxides or chalcogenide semiconductors have been studied for use in signal detection and analysis in biomedicine and photocatalysis. We devised...

The search for clean, low-cost, and renewable energy sources is one important challenge of modern industrial societies. [1] Hydrogen generated by photochemistry has been identified as a promising energy carrier with high energy density and zero CO 2 emission while being environmentally clean. [2,3] To set up a light-driven and hydrogen based economy an exploration of new materials for eco-friendly, economically viable, stable, and efficient photocatalysts is needed. [4] Noble metals like platinum, iridium, and ruthenium are efficient catalysts for the electrolysis of water, but their scarcity and high-costs limit large-scale technological use. [5] The development of cheap and active catalysts with long-term stability for the hydrogen or oxygen evolution reaction in standard electrolytes is an important goal. A general method to carry out the fluorination of metal oxides with poly(tetrafluoroethylene) (PTFE, Teflon) waste by spark plasma sintering (SPS) on a minute scale with Teflon is reported. The potential of this new approach is highlighted by the following results. i) The tantalum oxyfluorides Ta 3 O 7 F and TaO 2 F are obtained from plastic scrap without using toxic or caustic chemicals for fluorination. ii) Short reaction times (minutes rather than days) reduce the process time the energy costs by almost three orders of magnitude. iii) The oxyfluorides Ta 3 O 7 F and TaO 2 F are produced in gram amounts of nanoparticles. Their synthesis can be upscaled to the kg range with industrial sintering equipment. iv) SPS processing changes the catalytic properties: while conventionally prepared Ta 3 O 7 F and TaO 2 F show little catalytic activity, SPS-prepared Ta 3 O 7 F and TaO 2 F exhibit high activity for photocatalytic oxygen evolution, reaching photoconversion efficiencies up to 24.7% and applied bias to photoconversion values of 0.86%. This study shows that the materials properties are dictated by the processing which poses new challenges to understand and predict the underlying factors.

Understanding the collective behavior of ions at charged surfaces is of paramount importance for geological and electrochemical processes. Ions screen the surface charge, and interfacial fields break the centro-symmetry near the surface, which can be probed using second-order nonlinear spectroscopies. The effect of electrolyte concentration on the nonlinear optical response has been semi-quantitatively explained by mean-field models based on the Poisson−Boltzmann equation. Yet, to explain previously reported ion-specific effects on the spectroscopic response, drastic ion-specific changes in the interfacial properties, including surface acidities and dielectric permittivities, or strong ion adsorption/desorption had to be invoked. Here, we use sumfrequency generation (SFG) spectroscopy to probe the symmetrybreaking of water molecules at a charged silica surface in contact with alkaline metal chloride solutions (LiCl, NaCl, KCl, and CsCl) at various concentrations. We find that the water response varies with the cation: the SFG response is markedly enhanced for LiCl compared to CsCl. We show that within mean-field models, neither specific ion−surface interactions nor a reduced dielectric constant of water near the interface can account for the variation of spectral intensities with cation nature. Molecular dynamics simulations confirm that the decay of the electrochemical potential only weakly depends on the salt type. Instead, the effect of different salts on the optical response is indirect, through the reorganization of the interfacial water: the salt-type-dependent alignment of water directly at the interface can explain the observations.

In recent years the interaction of organophosphates and imines, which is at the core of Brønsted acid organocatalysis, has been established to be based on strong ionic hydrogen bonds. Yet, besides the formation of homodimers consisting of two acid molecules and heterodimers consisting of one acid and one base, also multimeric molecular aggregates are formed in solution. These multimeric aggregates consist of one base and several acid molecules. The details of the intermolecular bonding in such aggregates, however, have remained elusive. To characterize composition-dependent bonding and bonding dynamics in these aggregates, we use linear and nonlinear infrared (IR) spectroscopy at varying molar ratios of diphenyl phosphoric acid and quinaldine. We identify the individual aggregate species, giving rise to the structured, strong, and very broad infrared absorptions, which span more than 1000 cm –1 . Linear infrared spectra and density functional theory calculations of the proton transfer potential show that doubly ionic intermolecular hydrogen bonds between the acid and the base lead to absorptions which peak at ∼2040 cm –1 . The contribution of singly ionic hydrogen bonds between an acid anion and an acid molecule is observed at higher frequencies. As common to such strong hydrogen bonds, ultrafast IR spectroscopy reveals rapid, ∼ 100 fs, dissipation of energy from the proton transfer coordinate. Yet, the full dissipation of the excess energy occurs on a ∼0.8–1.1 ps time scale, which becomes longer when multimers dominate. Our results thus demonstrate the coupling and collectivity of the hydrogen bonds within these complexes, which enable efficient energy transfer.

Solid state reactions are slow, because the diffusion of atoms or ions through reactant, interme-diate and crystalline product phases is the rate-limiting step. This requires days or even weeks of...

Mixed-valence tungsten bronzes AxWO3 (A = alkali metal, NH4+, etc.) are a series of com-pounds with adaptive structural and compositional features that make them a hot research topic in thermoelectrics,...

NaCrO2 particles for high-rate sodium ion batteries were prepared on a multigram scale in segmented flow from chromium nitrate and sodium nitrate using a segregated flow water-in-oil emulsion drying process....

Aggregates formed between organo-phosphoric acids and imine bases in aprotic solvents are the reactive intermediates in Brønsted acid organo-catalysis. Due to the strong hydrogen-bonding interaction of the acids in solution, multiple homo- and heteroaggregates are formed with profound effects on catalytic activity. Yet, due to the similar binding motifs—hydrogen-bonds—it is challenging to experimentally quantify the abundance of these aggregates in solution. Here we demonstrate that a combination of nuclear magnetic resonance (NMR) and dielectric relaxation spectroscopy (DRS) allows for accurate speciation of these aggregates in solution. We show that only by using the observables of both experiments heteroaggregates can be discriminated with simultaneously taking homoaggregation into account. Comparison of the association of diphenyl phosphoric acid and quinaldine or phenylquinaline in chloroform, dichloromethane, or tetrahydrofuran suggests that the basicity of the base largely determines the association of one acid and one base molecule to form an ion-pair. We find the ion-pair formation constants to be highest in chloroform, slightly lower in dichloromethane and lowest in tetrahydrofuran, which indicates that the hydrogen-bonding ability of the solvent also alters ion-pairing equilibria. We find evidence for the formation of multimers, consisting of one imine base and multiple diphenyl phosphoric acid molecules for both bases in all three solvents. This subsequent association of an acid to an ion-pair is however little affected by the nature of the base or the solvent. As such our findings provide routes to enhance the overall fraction of these multimers in solution, which have been reported to open new catalytic pathways.