The Northwest quartz-pyrite-gold veins are situated 500 m east of the Lepanto fault in Mankayan, Luzon, Philippines. Most vein mineralization is hosted by the Lepanto metavolcanic basement rocks at an elevation between 700 and 1,050 m. The earliest stage, stage 1, is characterized by sphalerite + chalcopyrite + pyrite ± magnetite veins cutting the host rocks that were altered to chlorite + illite + epidote. Precious metal deposition started in stage 2 as electrum, native gold, and gold-silver tellurides deposited with pyrite, quartz, and carbonate. Deposition of gold and silver tellurides continued in stage 3a with abundant pyrite and tennantite-tetrahedrite solid solution intergrown with chalcopyrite, bornite, and minor sphalerite. The stage 3a veins and host-rock alteration are characterized by abundant muscovite and quartz, while the stage 3b veins and alteration consist of quartz, pyrophyllite, alunite, and dickite. Enargite and luzonite are the dominant sulfide minerals in stage 4, which are either disseminated in silicified host rock or within wide quartz veins. Lesser amounts of quartz and abundant pyrite with inclusions of enargite and luzonite were precipitated in stage 5. Microthermometry on fluid inclusions in quartz of stages 2, 3a, and 4 indicates boiling of the hydrothermal fluids. Bulk gas analysis on fluid inclusions in quartz shows that the stage 2 and 4 fluids had components derived from basaltic and andesitic magma, respectively. Fluids that formed stage 4 quartz were more diluted by meteoric water than the fluids that formed the stage 2 veins. Radiometric 40Ar/39Ar dating on alunite separated from the stage 3b advanced argillic alteration zone yielded 2.2 ± 0.1 Ma. Sulfur isotope compositions of the Northwest quartz-pyrite-gold deposit reveal a bulk δ34S of approximately 5‰, similar to the calculated value for the adjacent Far Southeast porphyry deposit. Calculated oxygen and hydrogen isotope ratios of the fluids of the Northwest quartz-pyrite-gold deposit stage 3b dickites are similar to those that formed the illite alteration in the Far Southeast porphyry deposit but are higher in δ18O when compared to the fluids that formed the kandites in the Lepanto enargite deposit. The northward cooling of mineralizing fluids previously reported in the Lepanto enargite deposit is not consistent with the mineralogic indications in the Northwest quartz-pyrite-gold deposit. These data indicate multiple mineralization events in the Mankayan district, which is one of the largest mineral districts in the western Pacific.

Several high‐sulfidation epithermal gold orebodies in the Mankayan Mineral District were formed in an environment that has been already affected by earlier porphyry‐type mineralization. This study reports the geologic and geochemical characteristics of the Carmen and Florence epithermal orebodies, which are located in the south of the Lepanto main enargite–gold orebody. The gold‐bearing epithermal quartz veins in the Carmen and Florence areas are of two types: (i) the enargite‐rich veins and (ii) the quartz–pyrite–gold (QPG) veins. The two types of veins are mainly hosted by the Cretaceous Lepanto Metavolcanics basement rocks, with minor veins cutting the Pleistocene Imbanguila Dacite Pyroclastics. The mineral assemblages and homogenization temperatures of fluid inclusions indicate that the Carmen and Florence orebodies were deposited by fluids varying from high to very high sulfidation state. The enargite and QPG epithermal veins of Carmen and Florence cut porphyry‐type quartz veinlet stockworks and veins that host polyphase hypersaline fluid inclusions that did not homogenize at or below 400°C. These high‐temperature quartz exhibits distinctly different mineral chemistry from the quartz of the QPG and enargite‐rich epithermal veins. In particular, the Ti content of quartz of the porphyry‐type veinlet stockwork is elevated (>100 ppm), whereas the Ti concentration of the epithermal vein quartz crystals are below detection limits. The Fe concentration of quartz is high in epithermal vein quartz (>300 ppm), whereas nearly undetected in the porphyry‐type stockwork veinlet quartz. Multiple generations of quartz with different mineral chemistry, fluid inclusions morphology, temperature, salinity and bulk gas compositions, and stable isotopic ratios indicate the variable hydrothermal conditions throughout the mineralization history of the Mankayan District. The temperature, pH, sulfidation state, oxidation state, and fluid composition vary among the orebodies in Carmen and Florence areas. Furthermore, the characteristics of earlier alteration affected the apparent characteristics of subsequent mineralization.

No abstract

No abstract