This paper presents the procedure for the calibration of a soil model represented by P-Y curves in the global finite element model of a drilling riser system using onboard measured data. In the case of lack of real data or data uncertainty regarding the soil properties of one specific well location, the soil model can be calibrated using measured data during the drilling campaign. The calibration procedure improves the accuracy on the prediction of the wellhead bending moment and stresses along the conductor pipe based on global riser analyses performed during the operation to assure the integrity of the well structure and thus, safe operations.
With the extension of the offshore drilling operations to water depths of 10,000 ft and beyond, the technical challenges involved also increased considerably. In this context, the management of the riser integrity through the application of computational simulations is capital to a safe and successful operation — particularly in harsh environments. One of the main challenges associated with keeping the system under safe limits is the recoil behavior in case of a disconnection from the well. The risk that an emergency disconnect procedure can take place during the campaign is imminent, either due to failure of the dynamic positioning system or due to extreme weather in such environments. Recent work [1] in the field of drilling riser dynamic analysis has shown that the recoil behavior of the riser after a disconnection from the bottom can be one of the main drivers of the level of top tension applied. Tension fluctuations can be very large as the vessel heaves, especially in ultra-deep waters where the average level of top tension is already very high. In order to be successful, a safe disconnection must ensure that the applied top tension is sufficient for the Lower Marine Riser Package (LMRP) to lift over the Blow-Out Preventer (BOP) with no risk of interference between the two. This tension should also not exceed a range in which the riser will not buckle due to its own recoil, that the telescopic joint will not collapse and transfer undesirable loads onto the drilling rig or that the tensioning lines will not compress. A good representation of such behavior in computational simulations is therefore very relevant to planning of the drilling campaign. A case study is presented herein, in which a recoil analysis was performed for a water depth of 11,483ft (3,500m). Numerical simulations using a finite element based methodology are applied for solving the transient problem of the riser disconnection in the time domain using a regular wave approach. A detailed hydro-pneumatic tensioning system model is incorporated to properly capture the effect of the anti-recoil valve closure and tension variations relevant during the disconnection. A reduction of conservativism is applied for the regular wave approach, where the maximum vessel heave likely to happen in every 50 waves is applied instead of the usual maximum in 1000 waves approach. ISO/TR 13624-2 [4] states that using the most probable maximum heave in 1000 waves is considered very conservative, as the event of the disconnection takes place in a very short period of time. The challenges inherent to such an extreme site are presented and conclusions are drawn on the influence of the overall level of top tension in the recoil behavior.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.