The 2020 Mw 6.8 Elazığ earthquake was the largest along the East Anatolian Fault (EAF) in over a century, providing valuable insights into its rupture behavior. We use satellite geodesy and seismology to detail the mainshock rupture, postseismic deformation, and aftershocks. The mainshock propagated mostly westward at ∼2 km/s from a nucleation point on an abrupt ∼10° fault bend. Only one end of the rupture corresponds to an established EAF segment boundary, and the earthquake may have propagated into the slip zone of the 1874 M ∼ 7.1 Gölcuk Gölu earthquake. It exhibits a pronounced (∼80%) shallow slip deficit, only a small proportion of which is recovered by early aseismic afterslip. The slow rupture velocity, shallow slip deficit, and minimal afterslip are characteristic of earthquakes hosted by faults of low‐to‐intermediate structural maturity, indicating that faults continue to evolve in important ways even as they accrue cumulative offsets of tens of kilometers.

The Mw 6.5 Norcia earthquake occurred on 30 October 2016, along the Mt Vettore fault (Central Apennines, Italy), it was the largest earthquake of the 2016-2017 seismic sequence that started 2 months earlier with the Mw 6.0 Amatrice earthquake (24 August). To detect potential slow slip during the sequence, we produced Interferometric Synthetic Aperture Radar (InSAR) time series using 12-to 6-day repeat cycles of Sentinel-1A/1B images. Time series indicates that centimeter-scale surface displacements took place during the 10 weeks following the Norcia earthquake. Two areas of subsidence are detected: one in the Castelluccio basin (hanging wall of the Mt Vettore fault) and one in the southern extent of the Norcia earthquake surface rupture, near an inherited thrust. Poroelastic and viscoelastic models are unable to explain these displacements. In the Castelluccio basin, the displacement reaches 13.2 ± 1.4 mm in the ascending line of sight on 6 January 2017. South of the Norcia earthquake surface rupture (a zone between the Norcia and Amatrice earthquakes), the postseismic surface displacements affect a smaller area but reach 35.5 ± 1.7 mm in ascending line of sight by January 2017 and follow a logarithmic temporal decay consistent with postseismic afterslip. Our analysis suggests that the structurally complex area located south of the Norcia rupture (30 October) is characterized by a conditionally stable frictional regime. This geometrical and frictional barrier likely halted rupture propagation during the Amatrice (24 August) and Norcia (30 October) earthquakes at shallow depth (<3-4 km).