A turbulent boundary layer structure which develop over a k-type rough wall displays several differences with those found on a smooth surface. The magnitude of the wake strength depends on the wall roughness. In the near-wall region, the contribution to the Reynolds shear stress fraction, corresponding to each event, strongly depends on the wall roughness. In the wall region, the diffusion factors are influenced by the wall roughness where the sweep events largely dominate the ejection events. This trend is reversed for the smooth-wall. Particle Image Velocimetry technique (PIV) is used to obtain the fluctuating flow field in the turbulent boundary layer in order to confirm this behavior. The energy budget analysis shows that the main difference between rough- and smooth-walls appears near the wall where the transport terms are larger for smooth-wall. Vertical and longitudinal turbulent flux of the shear stress on both smooth and rough surfaces is compared to those predicted by a turbulence model. The present results confirm that any turbulence model must take into account the effects of the surface roughness.

No abstract

No abstract

The flow downstream of a three-dimensional double backward facing step (3D DBWFS) is investigated for Reynolds number Reh ranging from 5×103 to8×104 (based on the first step height h). The flow is studied both qualitatively by means of laser tomoscopy and oil-flow visualizations and quantitatively by means of particle image velocimetry (PIV) measurements. In particular, the results show a mean flow asymmetry. A sensitivity study around zero degree sideslip has shown that the flow is bistable for this geometry. This bistability has been observed in two different wind tunnels for very different upstream conditions. As a main consequence, the zero degree drift angle could be a relevant validation case of unstable flow computation. More tests are carried out to understand and control this particular flow feature.

No abstract

Aero-acoustic coupling inside a deep cavity is present in many industrial processes. This investigation focuses on the pressure amplitude response, within two deep cavities characterized by their length over depth ratios (L/H=0.2 and 0.41), as a function of freestream velocities of a 2×2m2 wind tunnel. Convection velocity of instabilities was measured along the shear layer, using velocity cross-correlations. Experiments have shown that in deep cavity for low Mach numbers, oscillations of discrete frequencies can be produced. These oscillations appear when the freestream velocity becomes higher than a minimum value. Oscillations start at L/θ0=10 and 21 for L/H=0.2 and 0.41, respectively. The highest sound pressure level inside a deep cavity is localized at the cavity floor. A quite different behavior of the convection velocity was observed between oscillating and nonoscillating shear-layer modes. The hydrodynamic mode of the cavity shear layer is well predicted by the Rossiter model (1964, “Wind Tunnel Experiments on the Flow Over Rectangular Cavities at Subsonic and Transonic Speeds,” Aeronautical Research Council Reports and Memo No. 3438) when measured convection velocity is used and the empirical time delay is neglected. For L/H=0.2, only the first Rossiter mode is present. For L/H=0.41, both the first and the second modes are detected with the second mode being the strongest.

No abstract

No abstract