We report on magnetotransport measurements on InSb nanowire quantum dots. The measurements show that the quantum levels of the InSb quantum dots have giant g factors, with absolute values up to approximately 70, the largest value ever reported for semiconductor quantum dots. We also observe that the values of these g factors are quantum level dependent and can differ strongly between different quantum levels. The presence of giant g factors indicates that considerable contributions from the orbital motion of electrons are preserved in the measured InSb nanowire quantum dots, while the level-to-level fluctuations arise from spin-orbit interaction. We have deduced a value of Delta(SO) = 280 mueV for the strength of spin-orbit interaction from an avoided level crossing between the ground state and first excited state of an InSb nanowire quantum dot with a fixed number of electrons.

Growth and structural analysis of epitaxial InAs/InSb nanowire heterostructures are demonstrated for the first time. InSb segments are found to be perfect crystals, free of stacking faults or other major defects, and have a sharp interface with InAs (see image). After growth the seed particle is a single crystal nearly lattice matched to the nanowire. InSb segments are n‐type and form ohmic contacts with Ni/Au electrodes.

We demonstrate the growth of InSb-based nanowire heterostructures by metalorganic vapour phase epitaxy and use it to integrate InSb on extremely lattice-mismatched III-V nanowire templates made of InAs, InP, and GaAs. Influence of temperature, V/III ratio, and diameter are investigated in order to investigate the growth rate and morphology. The range of growth temperatures used for InSb nanowire growth is very similar to that used for planar growth due to the nature of the precursor decomposition. This makes optimization of growth parameters very important, and more difficult than for most other nanowire III-V materials. Analysis of the InSb nanowire epitaxial quality when grown on InAs, InP, and GaAs, along with InSb segment and particle compositions are reported. This successful direct integration of InSb nanowires, on nanowire templates with unprecedented strain levels show great promise for fabrication of vertical InSb devices.

InAs/GaSb nanowire heterostructures with thin GaInAs inserts were grown by MOVPE and characterized by electrical measurements and transmission electron microscopy. Down-scaling of the insert thickness was limited because of an observed sensitivity of GaSb nanowire growth to the presence of In. By employing growth interrupts in between the InAs and GaInAs growth steps it was possible to reach an insert thickness down to 25 nm. Two-terminal devices show a diode behavior, where temperature-dependent measurements indicate a heterostructure barrier height of 0.5 eV, which is identified as the valence band offset between the InAs and GaSb. Three-terminal transistor structures with a top-gate positioned at the heterointerface show clear indications of band-to-band tunnelling.