No abstract

No abstract

No abstract

Motivation: Caenorhabditis elegans, a roundworm found in soil, is a widely studied model organism with about 1000 cells in the adult. Producing high-resolution fluorescence images of C.elegans to reveal biological insights is becoming routine, motivating the development of advanced computational tools for analyzing the resulting image stacks. For example, worm bodies usually curve significantly in images. Thus one must ‘straighten’ the worms if they are to be compared under a canonical coordinate system.Results: We develop a worm straightening algorithm (WSA) that restacks cutting planes orthogonal to a ‘backbone’ that models the anterior–posterior axis of the worm. We formulate the backbone as a parametric cubic spline defined by a series of control points. We develop two methods for automatically determining the locations of the control points. Our experimental methods show that our approaches effectively straighten both 2D and 3D worm images.Contact: pengh@janelia.hhmi.orgSupplementary information: The example data sets and programs are available upon request.

Tin halide perovskites are promising candidates for preparing efficient leadfree perovskite solar cells due to their ideal band gap and high charge-carrier mobility. However, the notorious rapid crystallization process results in the inferior power conversion efficiency (PCE) of tin perovskite solar cells (TPSCs). Here, a facile method is employed to manage this crystallization process by using cold precursor solution that raises the critical Gibbs free energy to slow down the nucleation rate, sparing both space and time for crystal growth. In this way, highly oriented FASnI 3 films with micrometer-scale grains are fabricated and an increase of 70 mV in the open-circuit voltage is obtained for TPSCs. This method is compatible with other existed strategies such as additive engineering or the post-treatment method. The best-performing device that combines 0 °C precursor solution and post-treatment method demonstrates a PCE of 12.11%.

No abstract

The wetting behavior and affinity to side reactions of carbon‐based electrodes in vanadium redox flow batteries (VRFBs) are highly dependent on the physical and chemical surface structures of the material, as well as on the cell design itself. To investigate these properties, a new cell design was proposed to facilitate synchrotron X‐ray imaging. Three different flow geometries were studied to understand the impact on the flow dynamics, and the formation of hydrogen bubbles. By electrolyte injection experiments, it was shown that the maximum saturation of carbon felt was achieved by a flat flow field after the first injection and by a serpentine flow field after continuous flow. Furthermore, the average saturation of the carbon felt was correlated to the cyclic voltammetry current response, and the hydrogen gas evolution was visualized in 3D by X‐ray tomography. The capabilities of this cell design and experiments were outlined, which are essential for the evaluation and optimization of cell components of VRFBs.

No abstract