PZQ is the primary drug for treatment of schistosomiasis, but its efficiency is severely affected by its bitter taste. The main objective of this paper is the preparation of PMMA nanoparticles loaded with PZQ through in situ miniemulsion polymerizations and intended for oral formulations. Polymerizations are performed with an ultra turrax and a high‐pressure homogenizer. Obtained nanoparticles are analyzed by DSC, HPLC, DLS, GC, SEM, and PZQ dissolution profiles. Obtained results indicate the successful encapsulation of PZQ in all runs. Obtained data also show that the high‐pressure homogenizer leads to the best performance, allowing for preparation of stable latexes, with narrower particle size distributions and higher encapsulation efficiencies. magnified image

Epidemiological studies found that hepatitis E virus genotype 3 (HEV-3) infection was associated with chronic hepatitis and cirrhosis in immunocompromised patients. Our study aimed to investigate the relationship between the host immunosuppressive status and the occurrence of HEV-related chronic hepatitis. Here we describe a successful experimental study, using cynomolgus monkeys previously treated with tacrolimus, a potent calcineurin inhibitor immunosuppressant, and infected with a Brazilian HEV-3 strain isolated from naturally infected pigs. HEV infected monkeys were followed up during 160 days post infection (dpi) by clinical signs; virological, biochemical and haematological parameters; and liver histopathology. The tacrolimus blood levels were monitored throughout the experiment. Immunosuppression was confirmed by clinical and laboratorial findings, such as: moderate weight loss, alopecia, and herpes virus opportunistic infection. In this study, chronic HEV infection was characterized by the mild increase of liver enzymes serum levels; persistent RNA viremia and viral faecal shedding; and liver histopathology. Three out of four immunosuppressed monkeys showed recurrent HEV RNA detection in liver samples, evident hepatocellular ballooning degeneration, mild to severe macro and microvesicular steatosis (zone 1), scattered hepatocellular apoptosis, and lobular focal inflammation. At 69 dpi, liver biopsies of all infected monkeys revealed evident ballooning degeneration (zone 3), discrete hepatocellular apoptosis, and at most mild portal and intra-acinar focal inflammation. At 160 dpi, the three chronically HEV infected monkeys showed microscopic features (piecemeal necrosis) corresponding to chronic hepatitis in absence of fibrosis and cirrhosis in liver parenchyma. Within 4-months follow up, the tacrolimus-immunosuppressed cynomolgus monkeys infected with a Brazilian swine HEV-3 strain exhibited more severe hepatic lesions progressing to chronic hepatitis without liver fibrosis, similarly as shown in tacrolimus-immunosuppressed solid organ transplant (SOT) recipients. The cause-effect relationship between HEV infection and tacrolimus treatment was confirmed in this experiment.

For the last 40 years, praziquantel has been the standard treatment for schistosomiasis, a neglected parasitic disease affecting more than 250 million people worldwide. However, there is no suitable paediatric formulation on the market, leading to off-label use and the splitting of commercial tablets for adults. In this study, we use a recently available technology, direct powder extrusion (DPE) three-dimensional printing (3DP), to prepare paediatric Printlets™ (3D printed tablets) of amorphous solid dispersions of praziquantel with Kollidon® VA 64 and surfactants (Span™ 20 or Kolliphor® SLS). Printlets were successfully printed from both pellets and powders obtained from extrudates by hot melt extrusion (HME). In vitro dissolution studies showed a greater than four-fold increase in praziquantel release, due to the formation of amorphous solid dispersions. In vitro palatability data indicated that the printlets were in the range of praziquantel tolerability, highlighting the taste masking capabilities of this technology without the need for additional taste masking excipients. This work has demonstrated the possibility of 3D printing tablets using pellets or powder forms obtained by HME, avoiding the use of filaments in fused deposition modelling 3DP. Moreover, the main formulation hurdles of praziquantel, such as low drug solubility, inadequate taste, and high and variable dose requirements, can be overcome using this technology.

Atazanavir (ATV) has already been considered as a potential repurposing drug to 2019 coronavirus disease (COVID-19); however, there are controversial reports on its mechanism of action and effectiveness as anti-severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Through the pre-clinical chain of experiments: enzymatic, molecular docking, cell-based and in vivo assays, it is demonstrated here that both SARS-CoV-2 B.1 lineage and variant of concern gamma are susceptible to this antiretroviral. Enzymatic assays and molecular docking calculations showed that SARS-CoV-2 main protease (Mpro) was inhibited by ATV, with Morrison’s inhibitory constant (Ki) 1.5-fold higher than GC376 (a positive control) dependent of the catalytic water (H2Ocat) content. ATV was a competitive inhibitor, increasing the Mpro’s Michaelis–Menten (Km) more than sixfold. Cell-based assays indicated that different lineages of SARS-CoV-2 is susceptible to ATV. Using oral administration of ATV in mice to reach plasmatic exposure similar to humans, transgenic mice expression in human angiotensin converting enzyme 2 (K18-hACE2) were partially protected against lethal challenge with SARS-CoV-2 gamma. Moreover, less cell death and inflammation were observed in the lung from infected and treated mice. Our studies may contribute to a better comprehension of the Mpro/ATV interaction, which could pave the way to the development of specific inhibitors of this viral protease.