The paper analyzes the problems of exploitation of pipe outlets for the oil and gas industry and describes the special design of the outlet’s vane, which allows to extend its service life. However, this special shape of the vane requires new manufacturing technologies. The paper lists the technical requirements for the finished model of the outlet and the method of its manufacture. Based on them, an analysis was carried out, and has been proposed the application of additive technologies for the manufacture of a steel pipe outlet with the vane, namely, the method of Selective Laser Melting (SLM). The advantages and particularities of the method’s application are described, as well as the stages of the manufacturing process for manufacturing an outlet with a special shape of the vane.
A large number of parts have deep holes, therefore, rotary cutting tools, which represent relatively long and thin columns are used for holemaking. In this article we analyze the behavior of such tools under the influence of an axial compression load, in our case, the axial cutting force Fp , which differs fundamentally from the compression of short tools. Moreover, experience shows that when the cutting force Fp reaches a certain critical value equal to Fkp , a long straight column becomes unstable.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.