No abstract

A representative national survey on population exposure to radon in Italian dwellings was carried out from 1989 to 1994, with the co-operation of the National Health Service. The measurements were performed by 19 Regional Laboratories, all using the same techniques and protocols. A stratified, two-stage sampling procedure was used to sample families. The sampled families were approached door-to-door to maximize response. To optimize the quality of the measurements, two dosimeters, each containing two alpha track detectors, were placed together in one room (typically the bedroom) for two consecutive 6-mo periods. The distribution of annual radon concentration was derived from measurements in 4,866 dwellings. The average value is 75 Bq m(-3) and the fractions of dwellings above the reference levels of 150, 200, 400, and 600 Bq m-3 are 8.7%, 4.7%, 1.0%, and 0.2%, respectively. The geometric mean is 57 Bq m-3 while the geometric standard deviation is 2.0. The average values in the Italian Regions fall within the 20-120 Bq m-3 range. When the average radon concentration is examined vs. story, building materials seem to play a significant role. The average lifetime risk of lung cancer for chronic radon exposure of Italian population at home would be about 5 x 10(-3), using the risk factor proposed by the ICRP in 1993.

No abstract

The results obtained in different international intercomparisons on passive radon monitors have been analysed with the aim of identifying a suitable radon monitoring device for workplaces. From this analysis, the passive radon device, first developed for personal dosimetry in mines by the National Radiation Protection Board, UK (NRPB), has shown the most suitable set of characteristics. This radon monitor consists of a diffusion chamber, made of conductive plastic with less than 2 cm height, containing a CR-39 film (Columbia Resin 1939), as track detector. Radon detectors in workplaces may be exposed only during the working hours, thus requiring the storage of the detectors in low-radon zones when not exposed. This paper describes how this problem can be solved. Since track detectors are also efficient neutron dosemeters, care should be taken when radon monitors are used in workplaces, where they may he exposed to neutrons, such as on high altitude mountains, in the surroundings of high energy X ray facilities (where neutrons are produced by (gamma, n) reactions) or around high energy particle accelerators. To this end, the response of these passive radon monitors to high energy neutron fields has been investigated.

No abstract