Numerical simulations and parametric studies have been used to investigate the influence of potential poundings of seismically isolated buildings with adjacent structures on the effectiveness of seismic isolation. Poundings are assumed to occur at the isolation level between the seismically isolated building and the surrounding moat wall. After assessing some common force-based impact models, a variation of the linear viscoelastic impact model is proposed to avoid tensile impact forces during detachment, while enabling the consideration of permanent plastic deformations at the vicinity of the impact. A large number of numerical simulations of seismically isolated buildings with different characteristics have been conducted under six earthquake excitations in order to investigate the influence of various design parameters and conditions on the peak floor accelerations and interstorey deflections during poundings. The numerical simulations demonstrate that poundings may substantially increase floor accelerations, especially at the base floor where impacts occur. Higher modes of vibration are excided during poundings, increasing the interstorey deflections, instead of retaining an almost rigid-body motion of the superstructure, which is aimed with seismic isolation. Impact stiffness seems to affect significantly the acceleration response at the isolation level, while the displacement response is more insensitive to the variation of the impact stiffness. Finally, the results indicate that providing excessive flexibility at the isolation system to minimize the floor accelerations may lead to a building vulnerable to poundings, if the available seismic gap is limited.

No abstract

No abstract

SUMMARYThe current paper presents an efficient methodology for numerically simulating in three dimensions adjacent buildings that may experience pounding during strong earthquakes. In particular, a new approach to the numerical problem of spatial impact modeling that does not require the 'a priori' determination of the contact points is presented, taking also into account the geometry at the vicinity of an impact. In the current study, the buildings are simulated as linear multi-degree-of-freedom-systems, but the methodology can be easily extended to consider nonlinear behavior as well. A software application has been specifically developed to implement the proposed methodology, using modern object-oriented design and programming. The developed software is utilized in a simple example, and the computed results are compared with the corresponding analysis results obtained from a commercial general-purpose software application that uses typical contact elements for the simulation of impacts. A discussion follows on the advantages and capabilities of the proposed methodology and the developed software.

The majority of historical and heritage structures around the world consist of unreinforced masonry walls. A masonry structure is composed of masonry units, such as brick or marble blocks, with or without a joint filling material, such as mortar. A masonry with a joint material is usually made of two different materials (i.e. masonry units and mortar), representing a non-homogeneous and anisotropic structural component. In other words, masonry is a discontinuous structural component whose deformations and failure mechanism are governed by its blocky behavior. Some ancient masonry structures, such as ancient columns and colonnades, are constructed without any form of joint material between the individual blocks. Therefore, the isotropic elastic continuum-based models are not suitable for the simulation of the real nonlinear behavior of masonry walls under applied load.