No abstract

It is well known that ultrasonic melt treatment (UST) promotes grain refinement in aluminum alloys. Cavitation-aided grain refinement has been studied for many years; however, it is still not being applied commercially. The current article summarizes the results of experimental work performed on various alloying systems at different stages of solidification. The influence of UST parameters and solidification conditions on the final grain structure is analyzed. It was found that small additions of zirconium and titanium can significantly increase the efficiency of UST, under the stipulation that grain refinement is performed in the temperature range of primary solidification of Al 3 Zr. The possible mechanisms for this effect are discussed.

Semi-continuous direct-chill (DC) casting holds a prominent position in commercial aluminium alloy processing, especially in production of large sized ingots.Macrosegregation, which is the non-uniform chemical composition over the length scale of a casting, is one of the major defects that occur during this process. The fact that macrosegregation is essentially unaffected by subsequent heat treatment (hence constitutes an irreversible defect) leaves us with little choice but to control it during the casting stage. Despite over a century of research in the phenomenon of macrosegregation in castings and good understanding of underlying mechanisms, the contributions of these mechanisms in the overall macrosegregation picture; and interplay between these mechanisms and the structure formation during solidification are still unclear. This review attempts to fill this gap based on the published data and own results. The following features make this review unique: results of computer simulations are used in order to separate the effects of different macrosegregation mechanisms. The issue of grain refining is specifically discussed in relation to macrosegregation. This report is structured as follows. Macrosegregation as a phenomenon is defined in the Introduction. In Part 2, direct-chill casting, the role of process parameters and the evolution of structural features in the as-cast billets are described. In Part 3, macrosegregation mechanisms are elucidated in a historical perspective and the correlation with DC casting process parameters and structural features are made. The issue of how to control macrosegregation in direct-chill casting is also dealt with in Part 3. In Part 4, the effect of grain refining on macrosegregation is introduced, the current understanding is described and the contentious issues are outlined. The review is finished with conclusion remarks and outline for the future research.

No abstract

No abstract