Abstract:The present investigation was carried out at the Forestry Research Farm, Navsari Agricultural University; Navsari to evaluate the gamma rays at 10 kR, 20 kR and 30 kR induced variability in Jatropha curcas L. on germination, growth and yield for seven Jatropha genotypes (Phule J-1, Urlikanchan, Hansraj, SKN Big, Chhatrapati, Hansot and MPJ-55). The significantly maximum germination percentage (66.96%), seedling survival (74.18%), seedling collar diameter (0.958cm), shoot length (49.442cm), number of leaves per seedling (7.757) and leaf area (37. 58) was observed in Chhatrapati genotype during nursery stage. While low rate of gamma rays treatment (10 kR) had stimulatory effect for germination percentage, seedling survival, seedling collar diameter, shoot length, number of leaves per seedling and leaf area. However, higher gamma rays doses (30 kR) drastically reduced all studied characters. The interaction effect of genotype and gamma rays were significant for number of leaves per seedling. Further, it was not significant in other traits like germination percentage, seedling survival, seedling collar diameter, shoot length and leaf area.
However, only the plant height was found to be highest under Arjun, followed by Kalam trees. Among all the varieties tested, K-851 variety showed superiority for number of leaves (12.31) and number of branches per plant (3.96) and grain yield (2.66 gm per plant and 0.80 kg per plot) as compared to other varieties (at P=0.05). Therefore, this variety is suggested to grow in south Gujarat condition. Further, comparatively lower yield of crop under tree cover could be due to shade effect, which can be managed by regular pruning of tree branches.
The present investigation was conducted for mass multiplication of Jatropha curcas L. through axillary bud culture. For this nodal segment from 3-5 months old nursery grown plants were used as explants for axillary bud culture. The sterilization treatment involving dipping explants in 0.1 per cent HgCl 2 solution for 5 minutes resulted in minimum contamination and maximum establishment of nodal explants. The treatment MS medium supplemented with 1.0 mg/L BAP and 1.0 mg/L IAA was the best for culture establishment, shoot proliferation and multiplication of the axillary buds which exhibited highest value in each parameter like establishment (76.1%), number of days taken for shoot initiation (3.1 days), length of longest shoot (6.8 cm), number of leaves on main shoot (7.1) and number of shoots per explant (6.3). Among different treatments for root initiation, half MS media fortified with 1 mg/L IBA, 3 mg/ L NAA and 0.25 g AC gave best result in maximum number of rooting percentage (60) with minimum time taken for root initiation (13.3 days), produced maximum number of roots per shoots (5.1) and length of longest root (4.9 cm) when established shoots were treated with it. Such produced plantlets showed nearly cent per cent survival after hardening and acclimatization. It showed that explants surface sterilized with 0.1 per cent HgCl 2 solution for 5 minutes inoculated in MS medium supplemented with 1.0 mg/L BAP and 1.0 mg/L IAA and half MS media fortified with 1 mg/L IBA, 3 mg/L NAA and 0.25 g AC were best in shoot establishment and root development respectively for mass multiplication of J. curcas L. through axillary bud culture.
Abstract:The selected healthy branches of Jatropha curcas were cut into 15 cm and 25 cm length having 4 to 5 nodes in each category of apical portion (thickness < 1cm), middle portion (1.0 to 1.5 cm) and basal portion (1.5 to 2 cm). The base positions of apical, middle, basal portions of cuttings were dipped in the 100, 200, 400, 800 and 1000 ppm of IAA (Indole-3-acetic acid) and IBA (Indole-3-butyric acid) respectively for four hours. After which the cuttings were planted in the polypots filled with rooting media consists of sand, soil and farm yard manure (FYM) in the ratio of 1:2:1. Maximum sprouting (100%) was observed in 25 cm as well as 15 cm length cuttings of different portions. In case of 25 cm length different sections like apical cuttings when treated with 200 ppm, 800 ppm IAA and 400 ppm IBA, basal cutting with 800 ppm IAA and 200, 400 ppm IBA and middle cuttings with 200 ppm IAA, similarly 15cm length basal portion cutting treated with 400 ppm IAA produce 100 per cent sprouting. Other characters like rooting percentage (93.33%), root length (37.66cm), fresh biomass (73.21g) and dry biomass (34.06g) were observed maximum in apical portion cutting of 25 cm length treated with 100 ppm IBA, 800 ppm IBA, 100 ppm IAA and 100 ppm IAA respectively where as root number (17.0) found maximum in middle portion cutting of 15cm length treated with 1000 ppm IAA. It showed that the apical portion of 25 cm length cuttings treated with IAA and IBA resulted in maximum sprouting, rooting percentage, root length, fresh biomass and dry biomass production.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.