Abstract. A systematic study of black carbon (BC) vertical profiles measured at high-resolution over three Italian basin valleys (Terni Valley, Po Valley and Passiria Valley) is presented. BC vertical profiles are scarcely available in literature. The campaign lasted 45 days and resulted in 120 measured vertical profiles. Besides the BC mass concentration, measurements along the vertical profiles also included aerosol size distributions in the optical particle counter range, chemical analysis of filter samples and a full set of meteorological parameters. Using the collected experimental data, we performed calculations of aerosol optical properties along the vertical profiles. The results, validated with AERONET data, were used as inputs to a radiative transfer model (libRadtran). The latter allowed an estimation of vertical profiles of the aerosol direct radiative effect, the atmospheric absorption and the heating rate in the lower troposphere. The present measurements revealed some common behaviors over the studied basin valleys. Specifically, at the mixing height, marked concentration drops of both BC (range: from −48.4 ± 5.3 to −69.1 ± 5.5%) and aerosols (range: from −23.9 ± 4.3 to −46.5 ± 7.3%) were found. The measured percentage decrease of BC was higher than that of aerosols: therefore, the BC aerosol fraction decreased upwards. Correspondingly, both the absorption and scattering coefficients decreased strongly across the mixing layer (range: from −47.6 ± 2.5 to −71.3 ± 3.0% and from −23.5 ± 0.8 to −61.2 ± 3.1%, respectively) resulting in a single-scattering albedo increase along height (range: from +4.9 ± 2.2 to +7.4 ± 1.0%). This behavior influenced the vertical distribution of the aerosol direct radiative effect and of the heating rate. In this respect, the highest atmospheric absorption of radiation was predicted below the mixing height (~ 2–3 times larger than above it) resulting in a heating rate characterized by a vertical negative gradient (range: from −2.6 ± 0.2 to −8.3 ± 1.2 K day−1 km−1). In conclusion, the present results suggest that the BC below the mixing height has the potential to promote a negative feedback on the atmospheric stability over basin valleys, weakening the ground-based thermal inversions and increasing the dispersal conditions.

This study examines an innovative application of the aerosol deliquescence and crystallization determination, for corrosion prevention and energy-saving strategies in free-cooled data centers. Aerosol deliquescence and crystallization were investigated by combining standardized aerosol sampling techniques (i.e. EN-14907) with the assessment of the electrical effects of aerosol, while varying relative humidity within a specially designed aerosol exposure chamber. Aerosol samples collected in the Po Valley (Northern Italy) were analysed; a clearly defined hysteresis cycle (deliquescence and crystallization at 60.5 ± 0.8 and 47.9 ± 0.7 % of RH, respectively) was found. Results were applied to a data center designed for the Italian National Oil and Gas Company, making it possible to identify a critical area for direct free cooling at this data center. As a result, aerosol hydration was avoided (thus preventing aerosol from damaging electrical components) and a large amount of energy saved (using free cooling instead of air-conditioning); the potential energy saving achieved in this way was 79 % (compared to the energy consumption of a traditional air-conditioning system): 215 GWh of energy was saved, and 78 fewer kt of equivalent CO 2 was emitted per year. Moreover, in order to evaluate whether a real-time estimation of the aerosol hydration state within a data center could be performed, measured deliquescence and crystallization were compared through simulations performed using three different models: two thermodynamic models for deliquescence and a parametric model for crystallization. The results obtained tend to converge in terms of deliquescence, whereas in the case of crystallization, they failed to effectively simulate experimental aerosol behaviour.

The energy demands of data centers (DCs) worldwide are rapidly increasing, as are their environmental and economic costs. This paper presents a study conducted at Sannazzaro de' Burgondi (Po Valley), Italy, specifically aimed at optimizing the operating conditions of a DC designed for the Italian Oil and Gas Company (Eni) (5200 m(2) of Information Technology installed, 30 MW) and based on a direct free cooling (DFC) system. The aim of the study was to save the largest possible quantity of energy, while at the same time preventing aerosol corrosion. The aerosol properties (number size distribution, chemical composition, deliquescence relative humidity (DRH), acidity) and meteorological parameters were monitored and utilized to determine the potential levels of aerosol entering the DC (equivalent ISO class), together with its DRH. These data enabled us both to select the DC's filtering system (MERV13 filters) and to optimize the cooling cycle through calculation of the most reliable humidity cycle (60% of maximum allowed RH) applicable to the DFC. A potential energy saving of 81%, compared to a traditional air conditioning cooling system, was estimated: in one year, for 1 kW of installed information technology, the estimated energy saving is 7.4 MWh, resulting in 2.7 fewer tons of CO2 being emitted, and a financial saving of € 1100.

No abstract

No abstract