No abstract

No abstract

Although numerous research efforts have been made for the last two decades, the chronic problems of lithium-sulphur batteries (LSBs), i.e., polysulfide shuttling of active sulphur material and surface passivation of the lithium metal anode, still impede their practical application. In order to mitigate these issues, we utilized polyimide functionalized glass microfibers (PI-GF) as a functional separator. The water-soluble precursor enabled the formation of a homogenous thin coating on the surface of the glass microfiber (GF) membrane with the potential to scale and fine-tune: the PI-GF was prepared by simple dipping of commercial GF into an aqueous solution of poly(amic acid), (PAA), followed by thermal imidization. We found that a tiny amount of polyimide (PI) of 0.5 wt.% is more than enough to endow the GF separator with useful capabilities, both retarding polysulfide migration. Combined with a free-standing microporous carbon cloth-sulphur composite cathode, the PI-GF-based LSB cell exhibits a stable cycling over 120 cycles at a current density of 1 mA/cm2 and an areal sulphur loading of 2 mgS/cm2 with only a marginal capacity loss of 0.099%/cycle. This corresponds to an improvement in cycle stability by 200%, specific capacity by 16.4%, and capacity loss per cycle by 45% as compared to those of the cell without PI coating. Our study revealed that a simple but synergistic combination of porous carbon supporting material and functional separator enabled us to achieve high-performance LSBs, but could also pave the way for the development of practical LSBs using the commercially viable method without using complicated synthesis or harmful and expensive chemicals.

To inhibit Li-dendrite growth on lithium (Li)-metal electrodes, which causes capacity deterioration and safety issues in Li-ion batteries, we prepared a porous polyimide (PI) sponge using a solution-processable high internal-phase emulsion technique with a water-soluble PI precursor solution; the process is not only simple but also environmentally friendly. The prepared PI sponge was processed into porous PI separators and used for Li-metal electrodes. The physical properties (e.g., thermal stability, liquid electrolyte uptake, and ionic conductivity) of the porous PI separators and their effect on the Li-metal anodes (e.g., self-discharge and open-circuit voltage properties after storage, cycle performance, rate capability, and morphological changes) were investigated. Owing to the thermally stable properties of the PI polymer, the porous PI separators demonstrated no dimensional changes up to 180 °C. In comparison with commercialized polyethylene (PE) separators, the porous PI separators exhibited improved wetting ability for liquid electrolytes; thus, the latter improved not only the physical properties (e.g., improved the electrolyte uptake and ionic conductivity) but also the electrochemical properties of Li-metal electrodes (e.g., maintained stable self-discharge capacity and open-circuit voltage features after storage and improved the cycle performance and rate capability) in comparison with PE separators.