This study numerically and experimentally investigates a photonic approach for microwave time delay, which takes advantage of the redshift of the laser cavity resonance induced by external optical injection in a semiconductor laser. The strong enhancement around the redshifted cavity resonance not only amplifies the power, but also shifts the phase of the microwave signals carried by the optical injection. Such a microwave phase shift is approximately linear over a few gigahertz, leading to a constant microwave time delay over the frequency range. A different time delay can be achieved by simply adjusting the injection power or frequency. For the microwave frequencies up to 40 GHz investigated in this Letter, a continuously tunable range of more than 80 ps in time delay is achieved over an instantaneous bandwidth of approximately 7 GHz. The quality of the data carried by the microwave signals is mostly preserved after time delay. Thus, a bit-error ratio down to 10 at 2.5 Gb/s is achieved with a possible detection sensitivity improvement of 5 dB.

In radio-over-fiber systems, optical single-sideband (SSB) modulation signals are preferred to optical double-sideband (DSB) modulation signals for fiber distribution in order to mitigate the microwave power fading effect. However, typically adopted modulation schemes generate DSB signals, making DSB-to-SSB conversion necessary before or after fiber distribution. This study investigates a semiconductor laser at stable locking dynamics for such conversion. The conversion relies solely on the nonlinear dynamical interaction between an input DSB signal and the laser. Only a typical semiconductor laser is therefore required as the key conversion unit, and no pump or probe signal is necessary. The conversion can be achieved for a broad tunable range of microwave frequency up to at least 60 GHz. In addition, the conversion can be carried out even when the microwave frequency, the power of the input DSB signal, or the frequency of the input DSB signal fluctuates over a wide range, leading to high adaptability and stability of the conversion system. After conversion, while the microwave phase quality, such as linewidth and phase noise, is mainly preserved, a bit-error ratio down to 10^-9 is achieved for a data rate up to at least 8 Gb/s with a detection sensitivity improvement of more than 1.5 dB.