In recent years, a lot of attention has been devoted to monolayer materials, in particular to transition-metal dichalcogenides (TMDCs). While their growth on a substrate and their exfoliation are well developed, the colloidal synthesis of monolayers in solution remains challenging. This paper describes the development of synthetic protocols for producing colloidal WS2 monolayers, presenting not only the usual semiconducting prismatic 2H-WS2 structure but also the less common distorted octahedral 1T-WS2 structure, which exhibits metallic behavior. Modifications of the synthesis method allow for control over the crystal phase, enabling the formation of either 1T-WS2 or 2H-WS2 nanostructures. We study the factors influencing the formation of the two WS2 nanostructures, using X-ray diffraction, microscopy, and spectroscopy analytical tools to characterize them. Finally, we investigate the integration of these two WS2 nanostructured polymorphs into an efficient photocatalytic hydrogen evolution system to compare their behavior.
The solar‐to‐chemical energy conversion of greenhouse gas CO2 into carbon‐based fuels is a very important research challenge, with implications for both climate change and energy security. Herein, the key attributes of hydroxides and oxygen vacancies are experimentally identified in non‐stoichiometric indium oxide nanoparticles, In2O3‐x(OH)y, that function in concert to reduce CO2 to CO under simulated solar irradiation.
The development of strategies for increasing the lifetime of photoexcited charge carriers in nanostructured metal oxide semiconductors is important for enhancing their photocatalytic activity. Intensive efforts have been made in tailoring the properties of the nanostructured photocatalysts through different ways, mainly including band-structure engineering, doping, catalyst-support interaction, and loading cocatalysts. In liquid-phase photocatalytic dye degradation and water splitting, it was recently found that nanocrystal superstructure based semiconductors exhibited improved spatial separation of photoexcited charge carriers and enhanced photocatalytic performance. Nevertheless, it remains unknown whether this strategy is applicable in gas-phase photocatalysis. Using porous indium oxide nanorods in catalyzing the reverse water-gas shift reaction as a model system, we demonstrate here that assembling semiconductor nanocrystals into superstructures can also promote gas-phase photocatalytic processes. Transient absorption studies prove that the improved activity is a result of prolonged photoexcited charge carrier lifetimes due to the charge transfer within the nanocrystal network comprising the nanorods. Our study reveals that the spatial charge separation within the nanocrystal networks could also benefit gas-phase photocatalysis and sheds light on the design principles of efficient nanocrystal superstructure based photocatalysts.
In 2 O 3-x (OH) y nanoparticles have been shown to function as an effective gas-phase photocatalyst for the reduction of CO 2 to CO via the reverse water-gas shift reaction. Their photocatalytic activity is strongly correlated to the number of oxygen vacancy and hydroxide defects present in the system. To better understand how such defects interact with photogenerated electrons and holes in these materials, we have studied the relaxation dynamics of In 2 O 3-x (OH) y nanoparticles with varying concentration of defects using two different excitation energies corresponding to above-band-gap (318-nm) and near-band-gap (405-nm) excitations. Our results demonstrate that defects play a significant role in the excited-state, charge relaxation pathways. Higher defect concentrations result in longer excited-state lifetimes, which are attributed to improved charge separation. This correlates well with the observed trends in the photocatalytic activity. These results are further supported by density-functional theory calculations, which confirm the positions of oxygen vacancy and hydroxide defect states within the optical band gap of indium oxide. This enhanced understanding of the role these defects play in determining the optoelectronic properties and charge carrier dynamics can provide valuable insight toward the rational development of more efficient photocatalytic materials for CO 2 reduction.indium oxide | solar fuels | CO 2 hydrogenation | transient absorption | surface defects C oncerns over climate change and the projected rise in global energy demand have motivated researchers to develop alternative, more sustainable ways to generate energy from naturally abundant and renewable sources (1-3). An important challenge associated with using renewable energy sources, such as solar, is their inherent intermittent nature (4-6). The emerging field of solar fuels seeks to address this issue by storing radiant solar energy in chemical bonds, which can then be released on demand and act as a drop-in replacement for traditional fossil fuels (7-11). By using the greenhouse gas, CO 2 , currently regarded as a waste product, as a feedstock and converting it into valuable products such as solar fuels or platform chemicals, we could simultaneously address concerns over climate change and energy security while creating significant economic benefits (12)(13)(14). However, despite recent advances in the development of active materials that can drive the photocatalytic reduction of CO 2 into useful chemical species, much remains unknown about the fundamental physical properties that control the activity of a photocatalyst. To facilitate the rational development and improvement of photocatalytic materials, a detailed understanding of the complex interplay between chemical, optical, and electronic processes is needed.Indium oxide has many favorable optical, electronic, and surface properties that make it a compelling choice as a photocatalyst for CO 2 reduction. It has a relatively high conduction band, and common defects such as oxyge...
Thermal treatment of ultrathin films of hematite (α-Fe2 O3 ) under an atmosphere of 5 % H2 in Ar is presented as a means of activating α-Fe2 O3 towards the photoelectrochemical splitting of water. Spin-coated films annealed in air exhibited no photoactivity, whereas films treated in hydrogen exhibited a photocurrent response. X-ray photoelectron spectroscopy and UV/Vis absorption spectroscopy results showed that the H2 -treated films contain oxygen vacancies, which suggests improved charge transport. However, Tafel slopes, scan-rate dependent measurements, and kinetic analyses performed by using H2 O2 as a hole scavenger suggested that surface modification may also contribute to their induced photoactivity. Electrochemical impedance spectroscopy results revealed the buildup of a surface trap capacitance at the point of photocurrent onset for the hydrogen-treated films under illumination. A decrease in charge trapping resistance was also observed, which suggests improved transport of charges away from the surface.
Here we describe for the first time the synthesis of colloidally stable, brightly luminescent perfluorodecylcapped silicon nanocrystals and compare the properties of solutions and films made from them with those of their perhydrodecyl-capped relatives. The perfluorodecyl capping group compared to the perhydrodecyl capping group yields superior hydrophobicity and much greater resistance to air oxidation, the enhanced electron-withdrawing character induces blue shifts in the wavelength of photoluminescence, and the lowerfrequency carbon-fluorine stretching modes disfavor non-radiative relaxation pathways and boost the absolute photoluminescence quantum yield. Together these attributes bode well for advanced materials and biomedical applications founded upon perfluorodecyl-protected silicon nanocrystals. Keywordscapped, perfluorodecyl, luminescent, brightly, stable, oxidation, wettable, nanocrystal, non, silicon, film Disciplines Engineering | Physical Sciences and Mathematics Publication DetailsQian, C., Sun, W., Wang, L., Chen, C., Liao, K., Wang, W., Jia, J., Hatton, B., Casillas, G., Kurylowicz, M., Yip, Supporting Information PlaceholderABSTRACT: Here we describe for the first time the synthesis of colloidally-stable, brightly-luminescent perfluorodecylcapped silicon nanocrystals and compare the properties of solutions and films with the perhydrodecyl-capped relative. The perfluorodecyl capping group compared to the perhydrodecyl capping group yields superior hydrophobicity and much greater resistance to air oxidation, the enhanced electron withdrawing character induces blue shifts in the wavelength of photoluminescence and the lower frequency carbon-fluorine stretching modes disfavor non-radiative relaxation pathways and boost the absolute photoluminescence quantum yield. Together these attributes bode well for advanced materials and biomedical applications founded upon perfluorodecyl-protected silicon nanocrystals.The burgeoning research activity on new kinds of nanostructured silicon, made from one of the most abundant and green materials on earth, is striking.
Nonstoichiometric indium oxide nanoparticles, In 2 O 3−x (OH) y, have been shown to function as active photocatalysts for gas-phase CO 2 reduction under simulated solar irradiation. Herein we demonstrate that the choice of starting material has a strong effect on the photocatalytic activity of indium oxide nanoparticles. We examine three indium oxide materials prepared via the thermal decomposition of either indium(III) hydroxide or indium(III) nitrate and correlate their stability and photocatalytic activity to the number and type of defect present in the material. Further, we use 13 CO 2 isotope-tracing experiments to clearly identify the origins of the observed carbon-containing products. Significantly, we find that the oxidizing nature of the precursor anion has a substantial impact on the defect formation within the sample. This study demonstrates the importance of surface defects in designing an active heterogeneous photocatalyst and provides valuable insight into key parameters for the precursor design, selection, and performance optimization of materials for gas-phase CO 2 reduction.
The reverse water gas shift (RWGS) reaction driven by Nb2O5 nanorod‐supported Pd nanocrystals without external heating using visible and near infrared (NIR) light is demonstrated. By measuring the dependence of the RWGS reaction rates on the intensity and spectral power distribution of filtered light incident onto the nanostructured Pd@Nb2O5 catalyst, it is determined that the RWGS reaction is activated photothermally. That is the RWGS reaction is initiated by heat generated from thermalization of charge carriers in the Pd nanocrystals that are excited by interband and intraband absorption of visible and NIR light. Taking advantage of this photothermal effect, a visible and NIR responsive Pd@Nb2O5 hybrid catalyst that efficiently hydrogenates CO2 to CO at an impressive rate as high as 1.8 mmol gcat−1 h−1 is developed. The mechanism of this photothermal reaction involves H2 dissociation on Pd nanocrystals and subsequent spillover of H to the Nb2O5 nanorods whereupon adsorbed CO2 is hydrogenated to CO. This work represents a significant enhancement in our understanding of the underlying mechanism of photothermally driven CO2 reduction and will help guide the way toward the development of highly efficient catalysts that exploit the full solar spectrum to convert gas‐phase CO2 to valuable chemicals and fuels.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.