Sedimentation is a widely used technique in structural best management practices to remove pollutants from stormwater. However, concerns have been expressed about the environmental impacts that may be exerted by the trapped pollutants. This study has concentrated on stormwater ponds and sedimentation tanks and reports on the accumulated metal concentrations (Cd, Cr, Ni, Pb, and Zn) and the associated toxicity to the bacteria Vibrio fischeri. The metal concentrations are compared with guidelines and the toxicity results are assessed in relation to samples for which metal concentrations either exceed or conform to these values. The water phase metal concentrations were highest in the ponds whereas the sedimentation tanks exhibited a distinct decrease towards the outlet. However, none of the water samples demonstrated toxicity even though the concentrations of Cu, Pb, and Zn exceeded the threshold values for the compared guidelines. The facilities with higher traffic intensities had elevated sediment concentrations of Cr, Cu, Ni, and Zn which increased towards the outlet for the sedimentation tanks in agreement with the highest percentage of fine particles. The sediments in both treatment facilities exhibited the expected toxic responses in line with their affinity for heavy metals but the role of organic carbon content is highlighted.

A gully pot is often cleaned with the help of an eductor truck, which uses hydrodynamic pressure and a vacuum to loosen and remove the solids and standing liquid from a gully pot. This paper considers the polycyclic aromatic hydrocarbons (PAH) content in the gully pot mixture (water and sediment) after it has been discharged from the eductor truck. The results show that most PAH was attached to particles, and the dissolved phase represented approximately 22% of the total water concentration. No significant difference was found for the water phase between a housing area and a road, whereas a significant difference was found for NAP, ACE, FL, ANT, FLR, PYR, BaF, and BPY in the sediment at a 95% confidence level. Source identification showed that the PAH in the gully pot mixture came from mixed sources. Both the water and sediment phase exceed all or some of the compared guidelines. The result from this paper shows that not only the sediment needs to be discussed, but also the water phase created during the maintenance of different BMPs.

No abstract

No abstract