In the present investigation, facet-controlled Pd nanoparticles with nanocube (PdNC) and truncated octahedron (PdTO) morphologies, and their counterparts with half-a-monolayer of atomic Pt coated (0.5θPt-PdNC and 0.5θPt-PdTO) surfaces were prepared. All of them were characterized and evaluated as cocatalyst after supporting them on commercial titania (P25) (PdNC/P25, PdTO/P25, 0.5θPt-PdNC/P25, and 0.5θPt-PdTO/P25) under direct sunlight and/or one sun conditions for the oxidation of methanol to formaldehyde along with solar hydrogen production. PdNC/P25 shows higher activity for hydrogen generation compared to PdTO/P25; however, activity reversal occurs with the above cocatalysts, but, after Pt-coating with further enhanced activity. The highest conversion of methanol (0.2 μmol/h.mg) to 100% selective formaldehyde was observed with 0.5θPt-PdTO/P25, while other catalysts show significantly lower methanol conversion in the following order: 0.5θPt-PdTO/P25 > 0.5θPt-PdNC/P25 > PdNC/P25 > PdTO/P25. Pt-coated on (111) facets of PdTO simulates the activity associated as that of Pt(111) facets and demonstrating the highest and facet dependent activity. The present study is truly in resonance with exploiting the surface properties for heterogeneous catalysis, and highlights that less than a monolayer of Pt is sufficient to simulate the activity as that of bulk Pt. It is worth exploring this concept to other metals and substrates too.

While photocatalytic overall water splitting progress is mainly hindered by sluggish oxygen evolution kinetics, photocatalytic hydrogen generation using biomass components, such as glycerol as a sacrificial reagent, is a prudent...

The co-production of hydrogen and chlorine from sea-water splitting could be a potential, sustainable and attractive route by any methods. However, the challenges to overcome are many, and critically the...