No abstract

No abstract

No abstract

The topology optimization (TO) process has the objective to structurally optimize products in various industries, such as in biomechanical engineering. Additive manufacturing facilitates this procedure and enables the utility of advanced structures in order to achieve the optimal product design. Currently, orthopedic implants are fabricated from metal or metal alloys with totally solid structure to withstand the applied loads; nevertheless, such a practice reduces the compatibility with human tissues and increases the manufacturing cost as more feedstock material is needed. This article investigates the possibility of applying bioinspired lattice structures (cellular materials) in order to topologically optimize an orthopedic hip implant, made of Inconel 718 superalloy. Lattice structures enable topology optimization of an object by reducing its weight and increasing its porosity without compromising its mechanical behavior. Specifically, three different bioinspired advanced lattice structures were investigated through finite element analysis (FEA) under in vivo loading. Furthermore, the regions with lattice structure were optimized through functional gradation of the cellular material. Results have shown that optimal design of hip implant geometry, in terms of stress behavior, was achieved through functionally graded lattice structures and the hip implant is capable of withstanding up to two times the in vivo loads, suggesting that this design is a suitable and effective replacement for a solid implant.

In the present paper a continuous Finite Element Analysis (FEA) simulation method of the ball indentation hardness test is introduced in order to describe the deformation behavior of nanosilica composites and with this to extract precisely the material's stress-strain behavior. The developed procedure demonstrate in particular the adequacy of this method to determine the nanocomposites' elastic modulus which is compared with Halpin-Tsai and Lewis-Nielsen models as well as with experimental measurements taken from uniaxial tensile tests. The fracture area of all the tensile specimens was examined using a scanning electron microscope (SEM). It is shown that the correlation between the experimental results, the semi-empirical models and the FEA computational models concerning the elastic modulus values was satisfactory with very small deviations.

No abstract

No abstract

This paper investigates the mechanical behavior of additive manufactured Triply Periodic Minimal Surface (TPMS) structures, such as Gyroid, Schwarz Diamond and Schwarz Primitive. Fused Filament Fabrication (FFF) technique was utilized in order to fabricate lattice structures with different relative densities, at 10%, 20% and 30%, using Polylactic acid (PLA). The test specimens were formed by structural TPMS unit cells and they were tested under quasi-static compression. A finite element analysis (FEA) was performed in order to predict their stress-strain behavior and compare with the experimental results. The results revealed that each architecture influences the mechanical properties of the structure differently depending on the impact of size effect. The structures were designed as sandwich structures (with a top and bottom plate) to avoid significant deterioration of the mechanical behavior, due to the size effect and this was achieved at high relative densities. The Schwarz Diamond structure demonstrated the highest mechanical strength compared with the other architectures, while the Gyroid structure also revealed a similar mechanical performance. In addition, Schwarz Primitive structure showed increased energy absorption especially during plastic deformation. The overall results revealed that the integrity of the mechanical properties of the studied TPMS FFF printed structures deteriorates, as the relative density of the structures decreases.