In this article device-to-device (D2D) communication underlaying a 3GPP LTE-Advanced cellular network is studied as an enabler of local services with limited interference impact on the primary cellular network. The approach of the study is a tight integration of D2D communication into an LTE-Advanced network. In particular, we propose mechanisms for D2D communication session setup and management involving procedures in the LTE System Architecture Evolution. Moreover, we present numerical results based on system simulations in an interference limited local area scenario. Our results show that D2D communication can increase the total throughput observed in the cell area. Device-to-Device Communication as an Underlay to LTE-Advanced NetworksIn the feasibility analysis we studied D2D communication in a local area cellular network. Even though the cellular network may be interference limited already by the cellular communication alone, the D2D peers are still able to use the D2D communication opportunity if they are close and located in the same room.

No abstract

No abstract

In this article we propose to facilitate local peer-to-peer communication by a Device-to-Device (D2D) radio that operates as an underlay network to an IMT-Advanced cellular network. It is expected that local services may utilize mobile peer-to-peer communication instead of central server based communication for rich multimedia services. The main challenge of the underlay radio in a multi-cell environment is to limit the interference to the cellular network while achieving a reasonable link budget for the D2D radio. We propose a novel power control mechanism for D2D connections that share cellular uplink resources. The mechanism limits the maximum D2D transmit power utilizing cellular power control information of the devices in D2D communication. Thereby it enables underlaying D2D communication even in interference-limited networks with full load and without degrading the performance of the cellular network. Secondly, we study a single cell scenario consisting of a device communicating with the base station and two devices that communicate with each other. The results demonstrate that the D2D radio, sharing the same resources as the cellular network, can provide higher capacity (sum rate) compared to pure cellular communication where all the data is transmitted through the base station.

This paper describes three-dimensional (3-D) radio channel measurements at the base site in an urban environment. We Introduce a measurement concept which combines an RF switched receiver array and a synthetic aperture technique and allows full 3-D characterization of the channel. Additionally, dualpolarized patch antennas as array elements enable full determination of the polarization properties of the impinging signals. We describe measurements at over 70 different transmitter positions and three receiver array sites with different sectors and antenna heights. Our results show that the received energy is concentrated within identifiable clusters in the azimuth-elevation-delay domain. We demonstrate that the observed propagation mechanisms are mainly determined by the environment close to the base station. Street canyon propagation dominates also when the receiver array is at or even above rooftop level with the studied measurement distances. Thus, the azimuth spectrum at the BS site is fairly independent of the location of the mobile. Signal components propagating over the rooftop are often related to reflections from high-rise buildings in the surroundings.