No abstract

No abstract

The Cretaceous accretionary complexes of the Idonnappu Zone in the Urakawa area are divided into five lithological units, four of which contain greenstone bodies. The Lower Cretaceous Naizawa Complex consists of two lithologic units. The Basaltic Unit (B‐Unit) is a large‐scale tectonic slab of greenstone, consisting of depleted tholeiite similar to that of the Lower Sorachi Ophiolite (basal forearc basin ophiolite) in the Sorachi‐Yezo Belt. The Mixed Unit of Naizawa Complex (MN‐Unit) contains oceanic island‐type alkaline greenstones which occur as slab‐like bodies and faulted blocks with tectonically dismembered trench‐fill sediments. Repeated alternations of the two units in the Naizawa Complex may have been formed by the collision of seamounts with forearc ophiolitic body (Lower Sorachi Ophiolite) in the trench. The Upper Cretaceous Horobetsugawa Complex structurally underlies the Naizawa Complex in its original configuration, and it also contains greenstone bodies. Greenstones in the MH‐Unit occur as blocks and sedimentary clasts in a clastic matrix, and exhibit depleted tholeiite and oceanic‐island alkaline basalt/tholeiite chemistry. This unit is interpreted as submarine slide and debris flow deposits. Greenstones in the PT‐Unit occur at the base of several chert‐clastic successions. Most of the greenstones are severely sheared and show normal‐type mid‐ocean ridge basalt composition. The PT‐Unit greenstones are considered to have been derived from abyssal basement peeled off during accretion. The different accretion mechanism of the greenstones in the Naizawa and Horobetsugawa complexes reflects temporal changes in subduction zone conditions. Seamount accretion and tectonic erosion were dominant in the Early Cretaceous, due to highly oblique subduction of the old oceanic crust and minimal sediment supply. Whereas, thick sediments with minor mid‐ocean ridge basalt and olistostrome accreted in the Late Cretaceous, due to near‐orthogonal subduction of young oceanic crust with voluminous sediment supply.

We measured 87Sr/86Sr and 143Nd/144Nd ratios and carried out analytical test of Sr and Nd isotopic standards for the seven GSJ rock reference samples (hereafter GSJ-RRSs); JA-1, JB-1a, JB-2, JB-3, JG la, JGb-1 and JR-1. Our mean values of five separate analyses for the GSJ-RRSs are summarized in Table 1, in agreement with the ranges of previously published data. Our mean values for 87Sr/86Sr ratios of JB-2 and JGb-1 and 143Nd/144Nd ratio of JR-1, however, show a slightly large variation as compared with the other JGS-RRSs. Further data accumulation with specification of split/position number is required to evaluate homogeneity in Sr and Nd isotopic compositions.

The final lithospheric breakup of the Australian‐Antarctic rift system remains controversial due to sparse geological constraints on the nature of the basement along the ocean‐continent transition (OCT) zones. We present new interpretations of multichannel seismic reflection transects and new petrological data of dredged mantle rocks along the East Antarctic margin (Seamount B, offshore Terre Adélie). By combining both data sets, we show that a 50–100 km wide domain of cold and fertile subcontinental mantle was exhumed along the magma‐poor Antarctic margin. This study represents only the second locality, along with the Iberia‐Newfoundland margins, where the importance of exhumed mantle domains along OCTs can be clearly identified. The dredged peridotites preserve characteristics similar to mantle xenoliths found in syn‐ to post‐rift volcanism at the eastern end of the Australian margin (Victoria and Tasmania), indicating the exhumation of fertile subcontinental mantle during rifting between Australia and Antarctica. Seamount B represents the initial stages of exhumation of cold subcontinental lithosphere along an OCT during rifting. This thick mantle domain was likely affected by melt impregnation at high pressure (8 kbar), leading to the formation of plagioclase‐pyroxenites. The combination of continental rifted blocks, a wide domain of volcanic‐poor subcontinental mantle and (ultra‐) slow spreading is analogous to OCTs from the Jurassic Western Tethys and Iberia‐Newfoundland rifted margins. Additionally, evidence of melt stagnation at high pressure suggests that magmatism along the Australian‐Antarctic rifted margins was sufficient to form magnetic anomalies that can be used as isochrons despite their formation in lithosphere other than mature, steady‐state ocean crust.

No abstract

No abstract

Back-arc extension has been well documented in subduction plate tectonic regimes. However, the reasons why back-arc extensions are associated with some subduction systems but not others have remained elusive. Here, spatio-temporal variations in the composition of Cenozoic basalts in the northeast Asian continental margin are used to constrain the mechanism for episodic back-arc extensions. Using geochemical data sensitive to tectonic affinity, we show that typical volcanic arc compositions are located in the eastern margin of northeast Asia, whereas coeval intraplate volcanic compositions are located in the western part of northeast Asia, and that the intraplate and arc volcanism exhibit two eastward shifts, from 52 Ma to 33 Ma and from 33 Ma to 21 Ma. Intraplate basalts dated at ca. 11 Ma display a weak, arc-like geochemical signature, which suggests that the upwelling of asthenospheric mantle resulted in the remelting of previously melt-extracted lithospheric mantle modified by slab-derived fluids and the cessation of back-arc extensions. Thus, we propose that the eastward mantle flow resulted in eastward shifts of back-arc extensions that led to the development of extensive Cenozoic arc and intraplate volcanism in the northeast Asian continental margin.