[1] Bubbles bursting from whitecaps are considered to be the most effective mechanism for particulate matter to be ejected into the atmosphere from the Earth's oceans. To realistically predict the climate effect of marine aerosols, global climate models require process-based understanding of particle formation from bubble bursting. During a cruise on the highly biologically active waters of the northeastern Atlantic Ocean in the summer of 2006, the submicrometer primary marine aerosol produced by a jet of seawater impinging on a seawater surface was investigated. The produced aerosol size spectra were centered on 200 nm in dry diameter and were conservative in shape throughout the cruise. The aerosol number production was negatively correlated with dissolved oxygen (DO) in the water (r < À0.6 for particles of dry diameter D p > 200 nm). An increased surfactant concentration as a result of biological activity affecting the oxygen saturation is thought to diminish the particle production. The lack of influence of chlorophyll on aerosol production indicates that hydrocarbons produced directly by the photosynthesis are not essential for sea spray production. The upward mixing of deeper ocean water as a result of higher wind speed appears to affect the aerosol particle production, making wind speed influence aerosol production in more ways than by increasing the amount of whitecaps. The bubble spectra produced by the jet of seawater was representative of breaking waves at open sea, and the particle number production was positively correlated with increasing bubble number concentration with a peak production of 40-50 particles per bubble.
We present the first ever evaluation of sea spray aerosol eddy covariance (EC) fluxes at near coastal conditions and with limited fetch, and the first over water with brackish water (on average 7 ppt). The measurements were made on the island of Garpen in the Baltic Sea (56°23′ N, 16°06′ E) in September 2005. We found that wind speed is a major factor that is driving an exponential increase in sea spray sea salt emissions, comparable to previous studies over waters with higher salinity. We were able to show that the inclusion of a thermodenuder in the EC system allowed for the parallel measurements of the dry unheated aerosol flux (representing both organic and sea salt sea spray emissions) and the heated (300 °C) non-volatile sea salt emissions. This study’s experimental approach also included measurements of the artificial sea spray formed in a tank in locally sampled water at the same location as the EC fluxes. We attempted to use the EC aerosol flux measurements to scale the tank measurements to aerosol emissions in order to derive a complete size distribution for the sea spray emission fluxes below the size range (0.3–2 µm dry diameter) of the optical particle counters (OPCs) in the EC system, covering in total 0.01 µm to 2 µm diameter. In the wind directions with long fetches (corresponding to conditions similar to open sea), we were able to distinguish between the aerosol emission fluxes of dry aerosol and heated non-volatile (sea salt only) in the smallest size bins of the OPC, and could therefore indirectly estimate the organic sea spray fraction. In agreement with several previous ambient and tank experiments deriving the size resolved chemical mass concentration of sea salt and water-insoluble organic sea spray, our EC fluxes showed that sea sprays were dominated by sea salt at sizes ≥1 µm diameter, and by organics at the smallest OPC sizes. Since we used direct measures of the sea spray emission fluxes, we confirmed previous suggestions that this size distribution of sea salt and organics is a signature of sea spray aerosols. We were able to show that two sea salt source parameterizations (Mårtensson et al. (2003) and Salter et al. (2015)) agreed fairly well with our observed heated EC aerosol emission fluxes, as long as their predicted emissions were modified for the actual salinity by shifting the particle diameters proportionally to the cubic rote of the salinity. If, in addition, we added organics to the parameterized sea spray following the mono-layer model by Ellison et al. (1999), the combined sea spray parameterizations for sea salt and organics fell reasonably close to the observed fluxes for diameters > 0.15 µm, while one of them overpredicted the sea spray emissions below this size. The organic mono-layer model by Ellison et al. appeared to be able to explain most of the differences we observed between the aerosol emission fluxes with and without the thermodenuder.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.