For the validation of modelling results or the comparison of middle ear interventions, such as prostheses placement, average responses of middle ear vibrations are needed. One such response is the amplitude and phase of the vibration of the stapes footplate as a function of frequency. Average responses and their standard deviation are commonly obtained by calculating the mean of a number of measured responses at each frequency. A typical middle ear magnitude response curve shows a number of distinct peaks, and the location of these peaks varies between ears. By simply taking an average along the magnitude or phase response axis, the typical fine structure of the response curve is flattened out, delivering an average curve which no longer has the typical morphology of an individual response curve. This paper introduces methods to avoid this problem by first aligning the typical curve features along the frequency axis prior to calculating the average along the magnitude or phase axis, resulting in average magnitude and phase curves which maintain the typical morphology of the curve obtained for an individual ear. In the method, landmark points on the response magnitude curves are defined and the frequencies at which these points occur are averaged. Next, these average frequencies are used to align the landmark points between curves, prior to averaging values along the magnitude or phase axes. Methods for semi-automatic and manual assignment of landmark points and curve alignment are presented. After alignment, the correspondence between the original landmark frequencies and aligned frequencies is obtained together with the warping function which maps each original magnitude curve to its aligned version. The phase curves are aligned using the warping functions determined from the corresponding magnitude curves. Finally, a method is proposed to compare the data set of an individual measurement or model result to an aligned average curve in terms of magnitude and frequency by applying the alignment procedure to the individual curve.

The best sound transmission might be achieved by placing a PORP in contact with both the tympanic membrane and the handle of the malleus.

Ossicular fixation through otosclerosis, chronic otitis media and other pathologies, especially tympanosclerosis, are treated by surgery if hearing aids fail as an alternative. However, the best hearing outcome is often based on knowledge of the degree and location of the fixation. Objective methods to quantify the degree and position of the fixation are largely lacking. Laser vibrometry is a known method to detect ossicular fixation but clinical applicability remains limited. A new method, minimally invasive laser vibrometry (MIVIB), is presented to quantify ossicle mobility using laser vibrometry measurement through the ear canal after elevating the tympanic membrane, thus making the method feasible in minimally invasive explorative surgery. A floating mass transducer provides a clinically relevant transducer to drive ossicular vibration. This device was attached to the manubrium and drove vibrations at the same angle as the longitudinal axis of the stapes and was therefore used to assess ossicular chain mobility in a fresh-frozen temporal bone model with and without stapes fixation. The ratio between the umbo and incus long process was shown to be useful in assessing stapes fixation. The incus-to-umbo velocity ratio decreased by 15 dB when comparing the unfixated situation to stapes fixation up to 2.5 kHz. Such quantification of ossicular fixation using the incus-to-umbo velocity ratio would allow quick and objective analysis of ossicular chain fixations which will assist the surgeon in surgical planning and optimize hearing outcomes.

Objective: We compared the sound transmission using different types of total ossicular replacement prostheses (TORP); we then studied the performance of a new TORP that we designed inspired by the columella, the single ossicle found in birds. Methods: Stapedial vibrations were measured on nine freshly frozen human temporal bones with laser Doppler vibrometry. We then compared the performances of eight common TORP positions or designs as well as the new silver prototype of bird-type prosthesis, designed also according to our digital holography patterns of the human tympanic membrane (TM). Results: The TORPs placed in lateral contact with both the TM and the malleus handle outperformed, at most frequencies, those placed only in contact with the TM. The new bird-type prosthesis performed equally well or better than all other prostheses. Conclusion: If the malleus handle can be retained when placing a TORP, the best sound transmission can be achieved by placing the TORP in contact with both the distal part of the malleus handle and the TM. The good performance of our bird-type prosthesis suggests that there is still room for future improvement of prosthesis design to further optimize hearing outcomes after surgery.

No abstract