BackgroundOleaginous fungi can accumulate lipids by utilizing a wide range of waste substrates. They are an important source for the industrial production of omega-6 polyunsaturated fatty acids (gamma-linolenic and arachidonic acid) and have been suggested as an alternative route for biodiesel production. Initial research steps for various applications include the screening of fungi in order to find efficient fungal producers with desired fatty acid composition. Traditional cultivation methods (shake flask) and lipid analysis (extraction-gas chromatography) are not applicable for large-scale screening due to their low throughput and time-consuming analysis. Here we present a microcultivation system combined with high-throughput Fourier transform infrared (FTIR) spectroscopy for efficient screening of oleaginous fungi.ResultsThe microcultivation system enables highly reproducible fungal fermentations throughout 12 days of cultivation. Reproducibility was validated by FTIR and HPLC data. Analysis of FTIR spectral ester carbonyl peaks of fungal biomass offered a reliable high-throughput at-line method to monitor lipid accumulation. Partial least square regression between gas chromatography fatty acid data and corresponding FTIR spectral data was used to set up calibration models for the prediction of saturated fatty acids, monounsaturated fatty acids, polyunsaturated fatty acids, unsaturation index, total lipid content and main individual fatty acids. High coefficients of determination (R2 = 0.86–0.96) and satisfactory residual predictive deviation of cross-validation (RPDCV = 2.6–5.1) values demonstrated the goodness of these models.ConclusionsWe have demonstrated in this study, that the presented microcultivation system combined with rapid, high-throughput FTIR spectroscopy is a suitable screening platform for oleaginous fungi. Sample preparation for FTIR measurements can be automated to further increase throughput of the system.Electronic supplementary materialThe online version of this article (doi:10.1186/s12934-017-0716-7) contains supplementary material, which is available to authorized users.

No abstract

Interest in sustainable development has led to efforts to replace petrochemical-based monomers with biomass-based ones. Itaconic acid, a C5-dicarboxylic acid, is a potential monomer for the chemical industry with many prospective applications. cis-aconitate decarboxylase (CadA) is the key enzyme of itaconate production, converting the citric acid cycle intermediate cis-aconitate into itaconate. Heterologous expression of cadA from Aspergillus terreus in Escherichia coli resulted in low CadA activities and production of trace amounts of itaconate on Luria-Bertani (LB) medium (<10 mg/L). CadA was primarily present as inclusion bodies, explaining the low activity. The activity was significantly improved by using lower cultivation temperatures and mineral medium, and this resulted in enhanced itaconate titres (240 mg/L). The itaconate titre was further increased by introducing citrate synthase and aconitase from Corynebacterium glutamicum and by deleting the genes encoding phosphate acetyltransferase and lactate dehydrogenase. These deletions in E. coli's central metabolism resulted in the accumulation of pyruvate, which is a precursor for itaconate biosynthesis. As a result, itaconate production in aerobic bioreactor cultures was increased up to 690 mg/L. The maximum yield obtained was 0.09 mol itaconate/mol glucose. Strategies for a further improvement of itaconate production are discussed.

Hydrolyzed protein-rich byproducts from food production may find a variety of applications, for example, as rich ingredients of fermentation media. We have conducted a study of the enzymatic hydrolysis of three byproducts from Norwegian food industries: chicken byproducts, mixed pork and beef byproducts, and salmon viscera. The efficiency and optimization of the enzymatic hydrolysis were evaluated using endogenous enzymes alone and in combination with commercial proteases. Hydrolysis reactions were conducted with freshly thawed raw materials using short incubation times and including an initial temperature gradient from 4 to 60 °C to both harness the power of endogenous enzymes and minimize microbial contamination. Subsequently, hydrolysates were characterized by analyzing the total recovery of protein, the peptide molecular-weight distribution, and the composition of total and free amino acids. The action of endogenous enzymes played an important role in raw-material hydrolysis, particularly when hydrolyzing salmon viscera but less so when hydrolyzing chicken byproducts. For pork-beef and chicken byproducts, the addition of Alcalase or Papain improved protein recovery, reaching levels up to 90%. Next to showing efficient hydrolysis protocols, the present data also provide a comparison of the amino acid compositions of hydrolysates derived from these three different protein-rich byproducts. Growth studies showed that the obtained protein-rich hydrolysates from meat and fish industries are a promising alternative for expensive nitrogen sources that are commonly used for fermenting yeasts.

PentoseAspergillus niger a b s t r a c t L-Xylulose reductase is part of the eukaryotic pathway for L-arabinose catabolism. A previously identified L-xylulose reductase in Hypocrea jecorina turned out to be not the 'true' one since it was not upregulated during growth on L-arabinose and the deletion strain showed no reduced L-xylulose reductase activity but instead lost the D-mannitol dehydrogenase activity [17]. In this communication we identified the 'true' L-xylulose reductase in Aspergillus niger. The gene, lxrA (JGI177736), is upregulated on L-arabinose and the deletion results in a strain lacking the NADPH-specific L-xylulose reductase activity and having reduced growth on L-arabinose. The purified enzyme had a K m for L-xylulose of 25 mM and a m max of 650 U/mg.