No abstract

Multifrequency bioelectrical impedance analysis was used to estimate the ratio of extracellular water (ECW) to total body water in subjects with end-stage renal disease. The body's resistance was measured at frequencies ranging from 1 kHz to 1 MHz. The impedance index (height2/resistance) determined at low frequency (5 kHz) correlated most closely with ECW (r = 0.886) using sodium bromide dilution as the standard of comparison. In contrast, the ratio of height squared to resistance determined at high frequency (500 kHz) correlated most closely with total body water (r = 0.974) using deuterium oxide dilution as the standard of comparison. The ratio of resistance at 500 kHz to resistance at 5 kHz was directly correlated (r = 0.767) with the ratio of ECW to total body water. Multifrequency bioelectrical impedance analysis may assist in the evaluation of body water distribution in endstage renal disease and other clinical disorders of fluid volume and/or distribution.

A visual prosthesis for the blind using electrical stimulation of the visual cortex will require the development of an array of electrodes. Passage of current through these electrodes is expected to create a visual image made up of a matrix of discrete phosphenes. The quality of the visual sense thus provided will be a function of many parameters, particularly the number of electrodes and their spacing. We are conducting a series of psychophysical experiments with a portable "phosphene" simulator to obtain estimates of suitable values for electrode number and spacing. The simulator consists of a small video camera and monitor worn by a normally sighted human subject. To simulate a discrete phosphene field, the monitor is masked by an opaque perforated film. The visual angle subtended by images from the masked monitor is 1.7 degrees or less, depending on the mask, and falls within the fovea of the subject. In the study presented here, we measured visual acuity as a function of the number of pixels and their spacing in the mask. Visual acuity was inversely proportional to pixel density, and trained subjects could achieve about 20/26 visual acuity with a 1024 pixel image. We conclude that 625 electrodes implanted in a 1 cm by 1 cm area near the foveal representation of the visual cortex should produce a phosphene image with a visual acuity of approximately 20/30. Such an acuity could provide useful restoration of functional vision for the profoundly blind.

A visual prosthesis based on electrical stimulation of the visual cortex with an array of penetrating electrodes is expected to produce pixelized visual images consisting of punctate spots of light (phosphenes). We measured reading speed in subjects viewing text with optically simulated phosphene fields in order to obtain estimates of the following design parameters for such an electrode array: pixel number, pixel spacing, and visual-field size. Comparisons were made between scanning the text with eye movements and scanning the text with head movements. The results indicate that a 25 x 25 array of pixels representing four letters of text projected on a foveal visual field of 1.7 degrees is sufficient to provide reading rates near 170 words/min with scrolled text and near 100 words/min with fixed text.

The bicelechical impedance method was used to determine the haematocrit in patient blwd samples. The resistance (R) and reactance (X) of a constant volume of blood were measured at a low (50 kHz) and high (1 MHz) frequency. These dual-frequency impedance measuremen& were then used to determine the intracellular and extracellular (plasma) fluid volume of the blood and thus the haemocrit in 308 blood samples. The values compared favourably with the microhaematomit determined on the same samples, giving a correlation coefficient of 0.989 and a standard err01 estimation of 1.41%. Reactance at 1 MHz was a better parameter for predicting haematocrit than resistances. Factors affecting the resistivity of plasma, such as electrolyte and protein concentrations, were the ermr sources in the impedance technique.Our technique reduced such errors significantly. In conclusion, this electronic method can be used to measure haematocrit accurately and may be more desirable than conventional methods in certain clinical situations.