Redox flow batteries (RFBs) are one of the promising technologies for large‐scale energy storage applications. For practical implementation of RFBs, it is of great interest to improve their efficiency and reduce their cost. One of the key components of RFBs that can greatly influence the efficiency and final cost is the electrode. The chemical and structural nature of electrodes can modify the kinetics of redox reactions and the accessibility of the electroactive species to available active sites. The ideal electrocatalyst for RFBs must have good activity for the desirable redox reaction, provide a high surface area, and exhibit sufficient conductivity and durability over repeated use. One strategy is to coat the electrode with metal and metal oxide electrocatalysts. Metal electrocatalysts have the advantage of high conductivity, while metal oxide catalysts are usually less expensive and so more economically attractive. In order to gain a better understanding of the performance of the electrocatalysts in RFBs, a comprehensive review of the progress in the development of metal and metal oxide electrocatalysts for RFBs is provided and a critical comparison of the latest developments is presented. Finally, practical recommendations for advancement of electrocatalysts and effective transfer of knowledge in this field are provided.

An extremely stable, energy-dense (53.6 Ah L −1 , 2 m transferrable electrons), low crossover (permeability of <1 × 10 −13 cm 2 s −1 using Nafion 212 (Nafion is a trademark polymer from DuPont)), and potentially inexpensive anthraquinone with 2-2-propionate ether anthraquinone structure (abbreviated 2-2PEAQ) is synthesized and extensively evaluated under practically relevant conditions for use in the negolyte of an aqueous redox flow battery. 2-2PEAQ shows a high stability with a fade rate of 0.03-0.05% per day at different applied current densities, cut-off voltage windows, and concentrations (0.1 and 1.0 m) in both a full cell paired with a ferro/ferricyanide posolyte as well as a symmetric cell. 2-2PEAQ is further shown to have extreme long-term stability, losing only ≈0.01% per day when an electrochemical rejuvenation strategy is employed. From post-mortem analysis (nuclear magnetic resonance (NMR), liquid chromatography-mass spectrometry (LC-MS), and cyclic voltammetry (CV)) two degradation mechanisms are deduced: side chain loss and anthrone formation. 2-2PEAQ with the ether linkages attached on carbons non-adjacent to the central ring is found to have three times lower fade rate compared to its isomer with ether linkages on the carbon adjacent to the central quinone ring. The present study introduces a viable negolyte candidate for grid-scale aqueous organic redox flow batteries.

An iron complex, tris(4,4′‐bis(hydroxymethyl)‐2,2′‐bipyridine) iron dichloride is reported, which operates at near‐neutral pH with a redox potential of 0.985 V versus SHE. This high potential compound is employed in the posolyte of an aqueous flow battery, paired with bis(3‐trimethylammonio)propyl viologen tetrachloride in the negolyte, exhibiting an open‐circuit voltage of 1.3 V at near‐neutral pH. It demonstrates excellent cycling performance with a low temporal capacity fade rate of 0.07% per day over 35 days of cycling. The extended cycling lifetime is the result of low permeability and improved structural stability of the newly developed iron complex compared to that of the iron tris(bipyridine) complex. The combination of high redox potential and low capacity fade rate compares favorably with those of all previously demonstrated organic and organometallic aqueous posolytes. Extensive investigation into the possible degradation mechanisms, including post‐mortem chemical and electrochemical analyses, indicates that stepwise ligand dissociations of the iron complex are responsible for the reported capacity loss during cell cycling. This investigation provides unprecedented insight to guide further improvements of such metalorganic compounds for energy storage and conversion applications.

Aqueous organic redox flow batteries are promising candidates for large‐scale energy storage. However, the design of stable and inexpensive electrolytes is challenging. Here, we report a highly stable, low redox potential, and potentially inexpensive negolyte species, sodium 3,3′,3′′,3′′′‐((9,10‐anthraquinone‐2,6‐diyl)bis(azanetriyl))tetrakis(propane‐1‐sulfonate) (2,6‐N‐TSAQ), which is synthesized in a single step from inexpensive precursors. Pairing 2,6‐N‐TSAQ with potassium ferrocyanide at pH=14 yielded a battery with the highest open‐circuit voltage, 1.14 V, of any anthraquinone‐based cell with a capacity fade rate <10 %/yr. When 2,6‐N‐TSAQ was cycled at neutral pH, it exhibited two orders of magnitude higher capacity fade rate. The great difference in anthraquinone cycling stability at different pH is interpreted in terms of the thermodynamics of the anthrone formation reaction. This work shows the great potential of organic synthetic chemistry for the development of viable flow battery electrolytes and demonstrates the remarkable performance improvements achievable with an understanding of decomposition mechanisms.

An anthraquinone featuring a chiral carboxylate-capped methyl-branched side chain with an ether linkage, 2,2′-((9,10-dioxo-9,10-dihydroanthracene-2,6-diyl)bis(oxy))dipropionic acid (2,6-D2PEAQ), was synthesized and evaluated for use in aqueous redox flow batteries. It was found to have an extraordinary solubility of 2 M (4 M electrons), corresponding to a theoretical volumetric capacity of 107.2 Ah/L for the negative electrolyte, which is 10 times that of its unbranched counterpart. The 2,6-D2PEAQ molecule demonstrated stability against thermal decomposition and was extremely stable under cell cycling conditions. A capacity fade rate of 0.02%/day over 14 days was demonstrated in a 1.1 M 2,6-D2PEAQ nearly capacity-balanced cell when paired with a ferro-/ferricyanide posolyte at pH 7. Compared to other aqueous redox-active organic molecules, its demonstrated fade rate is lower than that of any molecule with a demonstrated volumetric capacity of ≥55 Ah/L, and its volumetric capacity is greater than that of any molecule with a demonstrated fade rate of ≤0.5%/day.

No abstract

Zinc electrodeposition and electrodissolution in methanesulfonic acid (MSA) electrolytes mixed with chloride or sulfate are investigated in a 3-electrode cell for eventual use in divided and undivided zinc-cerium redox flow batteries (RFB). Cyclic voltammetry and polarization experiments show that the

Aqueous organic redox flow batteries are promising candidates for large-scale energy storage. However, the design of stable and inexpensive electrolytes is challenging. Here, we report a highly stable, low redox potential, and potentially inexpensive negolyte species, sodium 3,3',3'',3'''-((9,10-anthraquinone-2,6-diyl)bis(azanetriyl))tetrakis(propane-1-sulfonate) (2,6-N-TSAQ), which is synthesized in a single step from inexpensive precursors. Pairing 2,6-N-TSAQ with potassium ferrocyanide at pH 14 yielded a battery with the highest open-circuit voltage, 1.14 V, of any anthraquinone-based cell with a capacity fade rate <10%/yr. When 2,6-N-TSAQ was cycled at neutral pH, it exhibited two orders of magnitude higher capacity fade rate. The great difference in anthraquinone cycling stability at different pH is interpreted in terms of the thermodynamics of the anthrone formation reaction. This work shows the great potential of organic synthetic chemistry for the development of viable flow battery electrolytes and demonstrates the remarkable performance improvements achievable with an understanding of decomposition mechanisms.