The Great Burgan reservoir is the largest sandstone oilfield in the world, it has been developed and produced since the 1930s. Historically developed through deviated wells, a new project of horizontal wells was initiated recently to produce from the UB3 reservoir unit. A pilot hole is usually required to identify the presence of productive sublayers and the depth of the oil-water contact (OWC), which must be avoided in the horizontal section. Elimination of the pilot hole would help to minimize the time and cost of development (Al Khalifa et al. 2020). The azimuthal ultra-deep resistivity mapping service (UDR) has proven its capability to eliminate the need for pilot holes by mapping reservoir boundaries and OWC on the fly, earlier than with traditional methods. This facilitates real-time geosteering to land the well in a single drilling run in the productive zone. Additionally, it helps to reduce non-productive time by making it easier to stop drilling and set casing above a target layer and to help optimize future well planning in field development. A feasibility study performed on offset wells showed promising potential from application of this method in the UB3. Real-time UDR geomapping detected multiple thin sand lenses on top of UB3 but showed that they were not of commercial capacity. The decision was made to continue drilling deeper for a larger sand layer. The UDR detected a massive sand below the smaller lenses and the well was landed in it. Early mapping also helped to optimize the landing with the desired inclination and dog-leg severity. The OWC was detected ~35 ft TVD below the landing point. Without UDR it would have been impossible to detect the OWC and very challenging to perform an accurate landing. The target could have been missed by landing either too shallow or too deep or with the wrong inclination. Following the landing of the well the lateral section was drilled through upper and lower lobes of the massive sand with a total cut of 1649 ft MD. This comprised 450 ft MD of upper lobe, 350 ft MD of transition interval, and 637 ft MD of lower lobe inside BU3, with an average porosity of 30 p.u. and a water saturation of less than 10%. Formation pressure tests measured mobility of up to ~3.4 D/cp. This case study demonstrates that utilization of the ultra-deep resistivity mapping service enabled a new approach to drilling lateral wells in the Burgan field development, improving reservoir insight and reducing well drilling time and cost.