Increasing use of metallic nanomaterials is likely to result in release of these particles into aqueous environments; however, it is unclear if these materials present a hazard to aquatic organisms. Because some dissolution of metal particles will occur, it is important to distinguish effects of nanoparticulates from dissolved metals. To address this issue, acute toxicity of soluble copper and 80 nm copper nanoparticle suspensions were examined in zebrafish. The results demonstrate that nanocopper is acutely toxic to zebrafish, with a 48 h LC50 concentration of 1.5 mg/L. Rapid aggregation of copper nanoparticles occurred after suspension in water, resulting in 50–60% of added mass leaving the water column. While dissolution of particulate copper occurred, it was insufficient to explain the mortality in nanocopper exposures. Histological and biochemical analysis revealed that the gill was the primary target organ for nanocopper. To further investigate the effects of nanocopper on the gill, zebrafish were exposed to 100 µg/L of nanocopper or to the concentration of soluble copper matching that present due to dissolution of the particles. Under these conditions, nanocopper produced different morphological effects and global gene expression patterns in the gill than soluble copper, clearly demonstrating that the effects of nanocopper on gill are not mediated solely by dissolution.

To properly assign mechanisms or causes for toxic effects of nanoscale materials, their properties and characteristics both outside and within the biological environment must be well understood. Scientists have many tools for studying the size, shape, and surface properties of particulates outside of the physiological environment; however, it is difficult to measure many of these same properties in situ without perturbing the environment, leading to spurious findings. Characterizing nanoparticle systems in situ can be further complicated by an organism's active clearance, defense, and/or immune responses. As toxicologists begin to examine nanomaterials in a systematic fashion, there is consensus that a series of guidelines or recommended practices is necessary for basic characterization of nanomaterials. These recommended practices should be developed jointly by physical scientists skilled in nano characterization and biological scientists experienced in toxicology research. In this article, basic nanoparticle characterization techniques are discussed, along with the some of the issues and implications associated with measuring nanoparticle properties and their interactions with biological systems. Recommendations regarding how best to approach nanomaterial characterization include using proper sampling and measurement techniques, forming multidisciplinary teams, and making measurements as close to the biological action point as possible.

No abstract

No abstract

SiO2/V2O5/TiO2 catalysts were synthesized for removing elemental mercury (Hg0) from simulated coal-combustion flue gas. Experiments were carried out in fixed-bed reactors using both pellet and powder catalysts. In contrast to the SiO2-TiO2 composites developed in previous studies, the V2O5 based catalysts do not need ultraviolet light activation and have higher Hg0 oxidation efficiencies. For Hg0 removal by SiO2-V2O5 catalysts, the optimal V2O5 loading was found between 5 and 8%, which may correspond to a maximum coverage of polymeric vanadates on the catalyst surface. Hg0 oxidation follows an Eley-Rideal mechanism where HCI, NO, and NO2 are first adsorbed on the V2O5 active sites and then react with gas-phase Hg0. HCI, NO, and NO2 promote Hg oxidation, while SO2 has an insignificant effect and water vapor inhibits Hgo oxidation. The SiO2-TiO2-V2O5 catalysts exhibit greater Hg0 oxidation efficiencies than SiO2-V2O5, may be because the V-O-Ti bonds are more active than the V-O-Si bonds. This superior oxidation capability is advantageous to power plants equipped with wet-scrubbers where oxidized Hg can be easily captured. The findings in this work revealed the importance of optimizing the composition and microstructures of SCR (selective catalytic reduction) catalysts for Hg0 oxidation in coal-combustion flue gas.