Purpose: Methane production potential in aerobic digestion was assessed according to feed to inoculum (F/I) ratio for food waste only, and mixing ratio of two materials for food waste and swine manure to give a basic data for the design of anaerobic digestion system. Methods: Anaerbic digestion test was performed using a lab scale batch reactor at 35 o C for six different feed to inoculum (F/I) ratios (0.50, 0.72, 1.14, 1.50, 2.14 and 3.41), three food waste to swine manure ratios (100:0, 60:40 and 40:60) with two different loading concentrations (10g VS/L and 30g VS/L). Results: For food waste only, the highest biogas yield of 1008 mL/gVS was obtained at 0.50 of F/I. For the co-digestion of food waste and swine manure mixture, the highest biogas yield of 1148 mL/gVS was obtained at a mixing ratio of 40:60 with loading concentration of 10g VS/L. Conclusions: F/I ratio for the food waste only, mixing ratio of food waste and swine manure, and co-substrate loading rate affected the biogas production rate. For the low loading rate, there was not so much difference according to the mixing ratio of food waste and swine manure, but for the high loading rate higher biogas yield was acquired for the co-digestion of food waste and swine manure than for the food waste alone (mixing ratio, 100:0).
The purpose of this study is to quantify the thermal conductivity of sewage sludge related to reaction temperature for the optimal design of a thermal hydrolysis reactor. We continuously quantified the thermal conductivity of dewatered sludge related to the reaction temperature. As the reaction temperature increased, the dewatered sludge is thermally liquefied under high temperature and pressure by the thermal hydrolysis reaction. Therefore, the bound water in the sludge cells comes out as free water, which changes the dewatered sludge from a solid phase to slurry in a liquid phase. As a result, the thermal conductivity of the sludge was more than 2.64 times lower than that of the water at 20 . However, above 200 , it became 0.704 W/m C, which is about 4% higher than that of water. As a result, the change in physical properties due to thermal hydrolysis appears to be an important factor for heat transfer efficiency.Implications: The thermal conductivity of dewatered sludge is an important factor the optimal design of a thermal hydrolysis reactor. The dewatered sludge is thermally liquefied under high temperature and pressure by the thermal hydrolysis reaction. The liquid phase slurry has a higher thermal conductivity than pure water.
-Saururus chinensis is used as a raw material of an anti-rheumatic, poultice, sedative and stomachic. The tea of dried Saururus chinensis leaves has a function of relaxing pains in back and breast and of treating stomach ailments. The plant has the functions of anti-inflammatory, depurative, diuretic, febrifuge and refrigerant. The extraction of functional material is carried out by methanol and ethanol solvents. Mechanochemical grinding is applied as a pretreatment process before extraction to enhance the extraction efficiency by increasing the surface area of the materials while changing the chemical properties of the materials. Extraction of functional materials from the Saururus chinensis after grinding as a pretreatment using the mechanochemical technology was accomplished in this study to investigate the effect of grinding on the antioxidant activities of the extract. Saururus chinensis was ground by the planetary ball mill and the morphology was analyzed by SEM. Mechanochemical pretreatment increased the yields of functional materials from 5.9 g to 6.4, 7.0, and 8.1 g after grinding of 30 minutes, 1 hour and 2 hours, respectively. Nitrite scavenging ability increased from 53.0-71.0% to 61.0-79.0% for the methanol extraction in the solution of pH 1.2. Also, Electron donating abilities were increased from 7.90-33.51% to 11.97-38.51% for the methanol extraction. The extract concentration for the half inhibition of DPPH radicals was reduced from 278 μg/mL in the original sample to 263 μg/mL in the sample after grinding for the methanol extraction.
-Houttuynia cordata is used as a raw material of oriental medicine to acquire antioxidant and anti cancer effect and to cure a heart disease. Mechanochemical technology not only reduces the size of the object but also changes the chemical properties of the object. Extraction of functional materials from the Houttuynia cordata after grinding as a pretreatment using the mechanochemical technology was conducted in this study to investigate the effect of grinding on the yields and antioxidant activities of the extract. Houttuynia cordata was ground by the planetary ball mill and the morphology was analyzed by SEM. Yields of functional materials were increased from 6.2 g in the sample without grinding to 7.0, 7.8, 8.8 g after grinding of 30 minutes, 1 hour and 2 hours, respectively. Nitrite scavenging abilities were increased from 57-77% to 69-86% as a result of mechanochemical pretreatment. Also, DPPH scavenging abilities for the methanol extraction were increased from 10.01-40.29% to 11.01-49.29% as a result of mechanochemical grinding.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.