No abstract

No abstract

No abstract

The synthesis of nanophase hydroxyapatite (nHA) is of importance in the field of biomaterials and bone tissue engineering. The bioactive and osteoconductive properties of nHA are of much benefit to a wide range of biomedical applications such as producing bone tissue engineered constructs, coating medical implants, or as a carrier for plasmid DNA in gene delivery. This study aimed to develop a novel low‐temperature dispersant‐aided precipitation reaction to produce nHA particles (<100 nm), which are regarded as being preferable to micron‐sized agglomerates of nHA. The variables investigated and optimized include the reaction pH, the rate of reactant mixing, use of sonication, order of addition, and concentration of the primary reactants, in addition, the effect of using poly(vinyl alcohol) (PVA) surfactant and Darvan 821A® dispersing agent during the reaction was also examined. It was found that by fine‐tuning the synthesis parameters and incorporating the dispersing agent, monodisperse, phase‐pure nano‐sized particles under 100 nm were attained, suitable for clinical applications in bone regeneration. © 2010 Wiley Periodicals, Inc. J Biomed Mater Res Part A, 2010.

The current review uses the material requirements of a new space propulsion device, the Variable Specific Impulse Magnetoplasma Rocket (VASIMR ® ) as a basis for presenting the temperature dependent properties of a range of dielectric ceramics, but data presented could be used in the engineering design of any ceramic component with complementary material requirements. A material is required for the gas containment tube (GCT) of VASIMR ® to allow it to operate at higher power levels. The GCT's operating conditions place severe constraints on the choice of material. A dielectric is required with a high thermal conductivity, low dielectric loss factor, and high thermal shock resistance. There is a lack of a representative set of temperature-dependent material property data for materials considered for this application and these are required for accurate thermo-structural modelling. This modelling would facilitate the selection of an optimum material for this component. The goal of this paper is to determine the best material property data values for use in the materials selection and design of such components. A review of both experimentally and theoretically-determined temperature-dependent & room temperature properties of several materials has been undertaken. Data extracted are presented by property. Properties reviewed are density, Young's, bulk and shear moduli, Poisson's ratio, tensile, flexural and compressive strength, thermal conductivity, specific heat capacity, thermal expansion coefficient and the factors affecting maximum service temperature. Materials reviewed are alumina, aluminium nitride, beryllia, fused quartz, sialon and silicon nitride.

No abstract

No abstract

No abstract