(1) Background: Quantitative evaluation of gait parameters can provide useful information for constructing individuals’ gait profile, diagnosing gait abnormalities, and better planning of rehabilitation schemes to restore normal gait pattern. Objective determination of gait phases in a gait cycle is a key requirement in gait analysis applications; (2) Methods: In this study, the feasibility of using a force myography-based technique for a wearable gait phase detection system is explored. In this regard, a force myography band is developed and tested with nine participants walking on a treadmill. The collected force myography data are first examined sample-by-sample and classified into four phases using Linear Discriminant Analysis. The gait phase events are then detected from these classified samples using a set of supervisory rules; (3) Results: The results show that the force myography band can correctly detect more than 99.9% of gait phases with zero insertions and only four deletions over 12,965 gait phase segments. The average temporal error of gait phase detection is 55.2 ms, which translates into 2.1% error with respect to the corresponding labelled stride duration; (4) Conclusions: This proof-of-concept study demonstrates the feasibility of force myography techniques as viable solutions in developing wearable gait phase detection systems.

No abstract

Introduction:Step counting can be used to estimate the activity level of people in daily life; however, commercially available accelerometer-based step counters have shown inaccuracies in detection of low-speed walking steps (<2.2 km/h), and thus are not suitable for older adults who usually walk at low speeds. This proof-of-concept study explores the feasibility of using force myography recorded at the ankle to detect low-speed steps. Methods: Eight young healthy participants walked on a treadmill at three speeds (1, 1.5, and 2.0 km/h) while their force myography signals were recorded at the ankle using a customized strap embedded with an array of eight force-sensing resistors. A K-nearest neighbour model was trained and tested with the recorded data. Additional three mainstream machine learning algorithms were also employed to evaluate the performance of force myography band as a pedometer. Results: Results showed a low error rate of the step detection (<1.5%) at all three walking speeds. Conclusions: This study demonstrates not only the feasibility of the proposed approach but also the potential of the investigated technology to reliably monitor low-speed step counting.

No abstract