No abstract

SiC/SiC composite is a candidate material for demonstration fusion power reactor (DEMO). To identify the inherent anisotropy of composites, it requires predicting axial/off-axial mechanical properties by various failure modes. This study evaluated failure behavior of SiC/ SiC composites by various mode tests such as tensile, Inter-laminar shear and Trans-thickness tensile modes. To provide strength anisotropy maps and discussed a method to predict this trend analytically. The identification of various fabric orientations from strength anisotropy maps clearly indicate that the composites failed by the mixed modes. The strength anisotropy can be described satisfactorily.

The tensile properties of two types of alumina (Al2O3 and Al2O3–SiO2) and short fiber-reinforced A366 alloy composite created by low-pressure infiltration have been studied. The applied pressure and temperature of molten alloy are 0.4 MPa and 1073 K, respectively. The composite containing 10 vol.% of fiber preform was sectioned and the microstructure was observed by scanning electron microscopy and energy dispersive X-ray spectroscopy. Tensile properties of Al2O3 fiber-reinforced A366 alloy composites were investigated, in conjunction with investigation of effects of amounts of SiO2 sol added as binder to fabricated preform and effects of changed chemical composition of Al2O3 fiber. The composite with SiO2 sol of 8 mass% has higher relative density in comparison with composite with SiO2 sol of 2 mass%. SiO2 sol raised the relative density of composite by the reaction with aluminum. In addition, the ultimate tensile strength of composite which has Al2O3 fiber-reinforced A366 alloy composite containing SiO2 sol of 8 mass% was approximately 20% higher than that of Al2O3–SiO2 fiber-reinforced A366 alloy composite containing SiO2 sol of 8 mass%.

No abstract

No abstract

No abstract

No abstract

No abstract