No abstract

No abstract

The fluorescent molecular rotor probes 4‐tricyanovinyl‐[N‐(2‐hydroxyethyl)‐N‐ethyl]‐aniline, tricyano‐4‐(dimethylamino) benzylidene, and tricyanovinyljulolidene have been used as extrinsic fluorescence probes for quantitative monitoring of water uptake in polymeric coatings. The presence of water causes plasticization of the polymer, which results in increased local mobility within the film. The nonradiative decay pathways of the rotor probes are increased as local mobility increases, and the resulting decrease in fluorescence intensity of the probes is directly proportional to the amount of water sorbed. Beyond allowing for the characterization of sorbent content, this fluorescence technique can be used to determine the diffusion coefficient of water in a polymer film. The relative change in fluorescence fits well to a Fickian diffusion model, yielding a diffusion coefficient for water of 3 × 10‐8 cm2/s in poly(vinyl acetate), and a value of 6 × 10‐9 cm2/s in a room‐temperature cured epoxypolyamide, in excellent agreement with diffusion coefficient values determined from gravimetric analysis. Preliminary studies also demonstrate the utility of molecular rotor probes to monitor water uptake in individual layers of multilayered polymer systems. © 1995 John Wiley & Sons, Inc.

This paper describes the development and optimization of a multi-residue veterinary drug screening method for whole milk. The drug residues of regulatory interest in milk include beta-lactams, sulfonamides, tetracyclines, fluoroquinolones, and macrolides. Milk samples were extracted with acetonitrile and the samples were then subjected to a clean-up procedure using a bonded solid-phase extraction cartridge and a molecular weight cut-off filter. Liquid chromatography/tandem mass spectrometry (LC/MS/MS) triple quadrupole electrospray methods were developed to monitor for the drugs in milk. Since established tolerance levels are set for most of these drugs in milk, the initial screening procedure was semi-quantitative, where samples were compared to the response of a positive control. The positive control, consisting of an extract from a portion of milk fortified with the drugs at half their allowed levels, was used to set the laboratory's minimum response criteria for unknown samples. Confirmatory analyses, with additional ion transitions for each residue, were performed on the same extracts.